Ubiquiti PBE5AC Users Manual

High-Performance
Integrated InnerFeed™
airMAX® ac Bridge

Model: PBE-5AC-620

Introduction

Thank you for purchasing the Ubiquiti Networks®
PowerBeam
you through installation and also includes warranty terms.

Package Contents

™

ac. This Quick Start Guide is designed to guide

Dish Reflector with

Mounting Bracket

Lower Pole

Bracket

Flat Washers

(M8, Qty. 5)

M8x150 Carriage

Bolts (Qty. 4)

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable
is designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

Antenna

Feed

Brace Screws

(M6, Qty. 4)

Stabilizer Brackets

(Qty. 2)

Pole Clamps

(Qty. 2)

Rear

Housing

Hex Head Bolts

(M8, Qty. 5)

M10x100 Bolts

(Qty. 2)

Gigabit PoE

Adapter with

Mounting Bracket

Support

Arm

Bracket Assembly

Lock Washers

Serrated Flange Nuts

(M10, Qty. 2)

Power

Cord

Upper Pole

(M8, Qty. 5)

High-Performance

™

Integrated InnerFeed

®

ac Bridge

airMAX

Model: PBE-5AC-620

Quick Start

Guide

™

Hardware Overview

Bottom View

Antenna Feed

Technology

Reset Button To reset to factory defaults, press and hold the

Reset button for more than 10 seconds while the PowerBeam

is already poweredon. Alternatively, the PowerBeam may be

reset remotely via a Reset button located on the bottom of the
Gigabit PoE Adapter.

Release Button After you assemble the PowerBeam, check

the Release button; it should be fully engaged in the Release
Button Slot of the Rear Housing. This ensures that the Antenna
Feed is locked into place. If you need to remove the Antenna
Feed, you must depress the Release button first.

Ethernet Port

Reset Button

Release Button

Reflector

Mounting Bracket

Alignment Pins

Rear Housing

Release

Button Slot

Cable Door

Dish