Ubiquiti NS2 User Guide

www.ubnt.com
NanoStation2
User Guide
USER INSTRUCTIONS
1. Launch web browser and type 192.168.1.20 to access NanoStation
2. Enter "UBNT" for both username and password
www.ubnt.com
TECHNICAL SPECIFICATIONS
Shock and Vibration
ETSI300-019-1.4
Power Method
Passive Power over Ethernet (pairs 4,5+; 7,8 return)
Max Power Consumption
4 Watts
Power Supply
Operating Temperature
-20C to +70C
Operating Humidity
5 to 95% Condensing
12V, 1A (12 Watts). Supply and injector included
Enclosure Characteristics
Outdoor UV Stabalized Plastic
Mounting Kit
Pole Mounting Kit included
Enclosure Size
26.4 cm x 8 cm x 3cm
Weight
0.4kg
Azimuth
Elevation
PHYSICAL / ELECTRICAL / ENVIRONMENTAL
Multi-Polarized
3dB Beamwidth Elevation
30 degrees
Polarization Selection
Software Controlled
3dB Beamwidth Azimuth
60 degrees
Polarization
Networking Interface
2 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
Gain
10dBi (2400-2500MHz)
RoHS Compliance
YES
REGULATORY / COMPLIANCE INFORMATION
SYSTEM INFORMATION
Processor Specs
Atheros AR2315 SOC, MIPS 4KC, 180MHz
Memory Information
16MB SDRAM, 4MB Flash
Wireless Approvals
FCC Part 15.247, IC RS210, CE
RADIO OPERATING FREQUENCY 2412-2462 MHz
ANTENNA
Outdoor (BaseStation Antenna Dependent):
Over 15km
RANGE PERFORMANCE
802.11b
802.11g OFDM
802.11g OFDM
TX SPECIFICATIONS
RX SPECIFICATIONS
802.11b
www.ubnt.com
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
!
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
ADDITIONAL INFORMATION AND COMPLIANCE
This is a Point-to-Point CPE Wireless Device.
Loading...