Ubiquiti AMO-2G10 Quick Start Guide

2.4 GHz 2x2 MIMO
Dual Polarity Omni Antenna

Model: AMO-2G10

Introduction

Thank you for purchasing the Ubiquiti Networks® airMAX®

2.4GHz 2x2 MIMO Dual Polarity Omni Antenna. This Quick
Start Guide is designed to guide you through the installation
of the antenna. This Quick Start Guide also includes the
warranty terms and is for use with the airMAX Omni Antenna,
modelAMO-2G10.

Package Contents

Antenna Pole Clamps

Serrated Flange Nuts

(M8, Qty. 4)

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable™
is designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

(Qty. 2)

RF Cables

(Qty. 2)

Carriage Bolts

(M8x120, Qty. 4)

2.4 GHz 2x2 MIMO
Dual Polarity Omni Antenna

Model: AMO-2G10

Quick Start Guide

Installation Requirements

• Rocket™M2 (sold separately)

• 13 mm wrench

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded
through the AC ground of the PoE.

We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable

Hardware Installation

1. Attach the RF Cables to the connectors labeled Chain 0 and

Chain 1 on the Rocket.

2. Align the mounting tabs on the back of the Rocket with

the Rocket mount, and slide the Rocket down to lock it
into place.

3. Attach the other ends of the RF Cables to the RF connectors

on the antenna.

*640-00043-03*

640-00043-03

4. Insert the four Carriage Bolts into the main mounting

bracket of the antenna.