Tyco Safety Sensormatic AMB44 User Guide

PRELIMINARY

© 2013 Sensormatic Electronics, LLC

Motorola MT2070
Handheld Scanner

Motorola MT2070
Base Charging Station

ZBAMB2070 EAS Deactivator
Module Assembly (dark
shaded parts)

ZBAMB2070
Mobile Handheld
Deactivator

For use with a Motorola MT2070
handheld barcode scanner

User Guide

The ZBAMB2070 Mobile Handheld
Deactivator combines a Motorola MT2070
barcode scanner with a rechargeable
battery-operated deactivator coil.

This guide covers:

 Using the device

 Charging the battery

 Replacing the battery.

Safety

WARNING:

 No serviceable parts! Opening

the deactivator may expose
you to electric shock! If the
deactivator appears defective,
have your loss prevention
manager or IT specialist return
it to the distributor.

 Never use a damaged

deactivator.

WARNING:

 The deactivator is not to be

used for scanning a person.
Always keep a distance of at
least 35cm (14in) between the
deactivation coil and another
person. Refer to the Safety
Notice on page 5.

 Ensure safety instructions

within this manual are observed
during the installation and/or
operation of the deactivator.

If you need assistance...

Contact your Sales Representative.

ZBAMB2070 MOBILE HANDHELD DEACTIVATOR 8200-0958-05, REV. 1B
INSTALLATION AND USER GUIDE

 For proper charging, rest the

deactivator in the Motorola
Base Charging Station exactly
as shown in the image. Resting
the deactivator any other way
will affect its operation.

1 of 5

PRELIMINARY

LEDs / Audio

Indicates

Green flash +
1 beep

Deactivation successful

Red flash +
3 beeps

Deactivation failed

LEDs / Audio

Indicates

Flashing red
and yellow

Replace the battery.

Red flash +
beep every
500ms until 30
seconds has
elapsed

Deactivator is out of
range of the Sync AP
device.
Solid red

Replace the
deactivator.

IIIIIIIIIIIIIIIIIIIII

IIIIIIIIIIIIIIIIIIIII

Using the Device

1. Remove the scanner/deactivator
from the Motorola Base Charging
Station.

2. Aim the scanner at the barcode and:

a) Pull the trigger. The scanner will

beep indicating a successful
scan.

b) Release the trigger; the LEDs on

the deactivator will flash yellow
for 3 seconds. Within this
window, perform step 3.

(If you were unable to perform
step 3 within this window, repeat
step 2.)

3. Swirl the deactivator coil in 2.54cm
(1in) circles no more than 11.4cm
(4.5in) from the barcode. Observe
deactivation indications.

Deactivation Indications

4. When finished, seat the
scanner/deactivator firmly into the
Motorola Base Charging Station to
maintain the battery charge.

Fault Indications

ZBAMB2070 MOBILE HANDHELD DEACTIVATOR 8200-0958-05, REV. 1B
INSTALLATION AND USER GUIDE

2 of 5