Tyco 37513, 37512 User Manual

Loading...

P

O

W

E

NITRO DOZER

RADIO CONTROL TMH POWER

R

CENTER

CARE!

have questions or difficulty operating this vehicle,

DO NOT RETURN IT TO THE STORE!

Call Toll-Free 1-888-557-TYCO (1-888-557-8926) technical help, or RAPID parts and service assistance.

37511-1920

MODEL NO. 37512 (27 MHz) MODEL NO. 37513 (49 MHz)

FEATURES

“SMART CIRCUITRY”

CONTENTS

9 functions

Your new Nitro Dozervehicle is equipped

 

with advanced “Smart Circuitry” designed to

 

Available in 2 frequencies

 

protect its electronic components under

 

(27 MHz and 49 MHz)

extreme operating conditions. If Nitro Dozer

 

Range up to 65'/20m

stops running during use, simply allow the joy-

 

sticks to return to their neutral positions

 

 

 

 

momentarily, then resume normal operation.

(1) Transmitter (1) TMHPower Nitro DozerVehicle

TOP VIEW

BOTTOM VIEW

 

Battery

2 Powerful

Gear Selector (under blade)

Compartment

Mabuchi Motors

Latch

 

(“F”= FAST; “P”= POWER)

 

 

 

Big,

 

 

Bad Dozer

F

P

Blade

(2)

Lockout

Buttons

Battery

Compartment

 

8 Super-Fast

ON/OFF

Transforming Tracks (2)

Driving Wheels

Switch

TRANSMITTER

Your transmitter is equipped with a special automatic “ON” battery-saving feature. Just turn your vehicle “ON.” Then push either transmitter stick and you will be able to run and control your vehicle.

 

 

Right Stick

Left Stick

 

Controls

Whip

Forward

Controls

Antenna

And Reverse

Forward

 

Of Right

And Reverse

 

 

Tread

Of Left

 

 

 

Tread

 

 

Automatic

 

 

"ON"

 

 

Power

 

 

Indicator

 

 

Light

 

 

Refer to label on transmitter and vehicle for frequency. Do not race vehicles with the same frequency.

BATTERY CHARGING/CARE

(Batteries and charger not included)

Your vehicle will not operate without the

TYCO® R/C TMH™ FlexPak™ Battery Pack Pack and Charger and 4 Hour Quick Charger.

The TMH™ FlexPak™ battery pack is designed for use exclusively in TYCO® R/C TMH™ power vehicles.

It will not work in any 6.0V or 9.6V NiCd battery-powered vehicles.

ALSO

AVAILABLE

 

Additional TMHFlexPak

Battery Pack

Have additional Battery Packs charged ahead of time for longer non-stop racing action. Uses the TMHQuick Charger.

Your TMH FlexPak battery pack

features a unique design (Patent Pending) which allows it to be configured in different ways R/C vehicles. This feature allows maximum vehicle performance and design flexibility. To FlexPak battery pack for use in Nitro Dozer, please refer to Step 2, “Battery Installation.”

1.Plug the battery charger into standard wall outlet.

2.Hold the battery pack fully open, with the metal contacts at the top, as shown. The marked “1” and “2” in the upper left-hand corner should be facing you. Now slide pack securely into the charger.

3.To disconnect, push the red button on the side of the charger. Hold the red button while you slide out the battery pack.

4.New battery packs must be charged for 5 1/2 hours the first two times charged. subsequent charges will require only 4 hours.

5.After charging for 4 hours, the battery pack will feel warm. This is normal for fully batteries.

6.Charging the battery pack for more than 4 hours will not give you longer running

7.Unlike alkaline batteries, which lose power gradually, your TMH FlexPak battery its normal running time, depending on your particular vehicle, and then lose most power at once. It is now time to recharge the battery pack.

8.Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TMH FlexPak battery may be recharged at any time, irrespective of the level of charge remaining in the you do not have to wait until the battery pack is fully discharged to recharge it.

9.After use, the battery pack will be hot! Wait at least 20 minutes until the battery down before recharging. Recharging a hot battery pack will greatly reduce the times your battery pack can be recharged.

BATTERY PACK CARE

Because of its unique design, other battery chargers will be unable to charge your TMH To charge your battery pack, use only the TYCO R/C TMH FlexPak battery charger.

1

2

1

2

CAUTIONS

DO NOT RECHARGE BATTERY PACK IF IT’S HOT. ALLOW IT TO COOL BEFORE

DO NOT CHARGE A BATTERY PACK THAT SHOWS LEAKAGE OR CORROSION.

DO NOT DISASSEMBLE THE BATTERY PACK. THE BATTERY PACK IS A SEALED NiMH

DO NOT DISPOSE OF THE BATTERY PACK IN FIRE.

EXERCISE CAUTION IN HANDLING A HOT BATTERY PACK.

IF BATTERY PACK AND/OR CHARGER ARE WET, THOROUGHLY DRY BEFORE CHARGING.

SPECIAL NOTE TO ADULTS:

Unlike

The battery charger is age-graded for ages 8 and over; the battery charger should not be operated in the presence of children under 8 years of age without adult supervision. Adult supervision is recommended.

• Regularly examine for damage to the plug, enclosure and other parts. In the event of any

for

 

damage, the toy must not be used with the transformer until the damage has been repaired.

 

• This toy is not intended for children under 3 years old. The transformer is not a toy.

 

BATTERY.

.

+ 2 hidden pages