Tweco 9-7717 User Manual

COOLANT TEMPERATURE CORRECTION KIT

Manual 0-5291

AC/UC Overtemp Correction Kit

Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
Telephone: [phone]
Email: [e-mail]
www.victortechnologies.com

General Information

This kit allows for updating the coolant temperature sensing to avoid errors in over temperature readings .

Contents

The following components are included in this kit:

Item Description Catalog Number Quantity

1 Overtemp Correction Harness 9-7717 1

Part Number: 9-7717

Assembly Instructions

Assembly Procedure

WARNING

Disconnect primary power at the source before performing any inspection or repairs.

Only a qualifi ed technician should perform this procedure.

Determine which Transducer you have now.

1. Remove the right side panel as you face the power supply from the front.

2. Locate the Transducer that is attached by a screw to the brass fi tting on the inside of the rear panel above the
coolant tank. If you have the larger one shown on the left, you do not need to install this new harness. If you
have the smaller one shown on the right, then you do need to install this new harness kit.

Larger Transducer Smaller Transducer

Manual 0-5265 Rev. AA 1

COOLANT TEMPERATURE CORRECTION KIT

3. Follow the wires from the Transducer until you locate the connectors shown in the next illustration and dis­connect them.

4. Install the new harness kit between these two connectors.

5. Replace the side panel.

Your are done. Let’s cut some metal.

Manual 0-5265 Rev. AA 2