Tweco 8-3441 User Manual

Manual 0-4837

RPT Adapter Kit

82 Benning Street, West Lebanon, NH 03784 USA

[phone] • www.thermal-dynamics.com

Catalog # 8-3441

Installation Instructions

General Information

This kit provides a switch to toggle from "Hand" to "Mach" for use with the Thermal Dynamics ATC Adapter Kit, on
Hypertherm* Powermax* 1000, powermax* 1250, & powermax* 1650 power supplies. Do not use this kit with any other
equipment. Read these instructions before starting the replacement procedure. Keep these instructions for future
reference.

Supplied Parts

The kit includes:

• Toggle Switch and Mounting Bracket Assembly

• Two Screws

• Instructions

Assembly

NOTE:

The following illustration shows proper connections between the Thermal Dynamics 1Torch® ATC adapter harness
and the Toggle Torch Mode Switch (provided in this kit). If you are installing both of these at the same time you must
complete the ATC Adapter Harness installation before proceeding with the Toggle Switch.

Toggle Switch Adapter Kit

Pm1650/1250/1000

1

2

3

47

5

6

10

8

11

912

Hand

Mach

Toggle
Switch

Art # 0-07097

© 2006 Thermal Dynamics Corp., Printed in USA .

* HYPERTHERM and powermax are registered trademarks of Hypertherm, Inc.

Manual 0-4837 1 January 19, 2006

Adapter

Fitting

Torch

Caution

Disconnect power and air from the power supply before attempting this installation.

1. Open the access door on the Power Supply.

2. Locate the angled surface at the rear of the torch connection area where the switch will be located. Position the
Switch Bracket approximately 1/2" down from the top as shown and mark the two holes for drilling.

January 19, 2006 2 Manual 0-4837