Tweco 7-7500 User Manual

General Information
The Two Stage Air Line Filter Kit will remove moisture and contaminants from the air stream when using com­pressed air. The filter is capable of filtering to at least 5 microns. The filter assembly is pre-assembled at the fac­tory and need only be attached to the power supply.
Parts List
• Installation Instructions - 1 each
• 10-32 x 1/2 Phillips Head Swagform Screws - 2 each
• Filter Mounting Bracket - 1 each
• Air Line Filter Assembly - 1 each
• 1/4 NPT Sreet Elbow - 1 each
• Filter To Regulator Hose Assembly - 1 each
Two Stage Air Line Filter Kit
Regulator/Filter
Assembly
Manual 0-2541
(Catalog # 7-7500)
Installation Instructions
Mounting Holes
Installation
NOTE
The Two Stage Air Line Filter Assembly is to be used with the Regulator/Filter Assembly installed on the rear of the unit.
Install the Two Stage Air Line Filter Kit per the following procedure:
1. Remove the gas supply input hose from the Regula­tor/Filter Assembly at the rear of the power supply if already installed.
2. Locate the two mounting holes on the rear of the unit and secure the Air Filter Mounting Bracket to the panel using the two screws provided.
Mounting
Screws
Air Filter
Mounting Bracket
A-01025
Figure 1: Air Filter Mounting Bracket Installation
3. Slide the Air Line Filter Assembly into the mounting bracket. The Filter Assembly will snap into place.
Manual 0-2541 1 Date: 3/22/99
Filter To Regulator
Hose Asembly
1/4 NPT
Elbow
Regulator/Filter
Assembly
Air Filter
Mounting Bracket
Filter
Assembly
A-01026
Figure 2: Two Stage Air Line Filter Installation
4. Connect the output of the Air Line Filter Assembly to the input of the Regulator/Filter Assembly with the Fil­ter to Regulator Hose Assembly provided.
5. Install the supplied 1/4 NPT Street Elbow into the input port of the Air Line Filter Assembly.
6. Connect the gas supply hose to the street elbow.
Replacement Filter Elements
The Following are the replacement filter elements for the Two Stage Air Line Filter:
Element Catalog #
1st Stage 9-1021
2nd Stage 9-1022
NOTE
Every effort has been made to provide com­plete and accurate information in this manual. However, the publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused by errors or omis­sions in this Manual, whether such errors re­sult from negligence, accident, or any other cause.
Manual 0-2541 Installation Instructions 5/17/94
Date: 3/22/99 2 Manual 0-2541
Loading...