
8000 Series
Showerhead
32mm
Maintenance
Instructions
Installers please note these InstructIons are to be left wIth the user
2180872D - July 2014

8000 SERIES SHOWERHEAD
1
Body
2
3
Removal
button
Lever
Spray
plate
This instruction book covers the operation and
cleaning of the showerhead.
SHOWERHEAD SPRAY POSITIONS
Five showerhead patterns are available.
Adjust the spray pattern by turning the lever
on the showerhead in either direction until the
desired pattern is obtained. These positions are
located at 4, 5, 6, 7 and 8 o'clock, when the
showerhead is in the vertical position.
REMOVING THE SPRAY PLATE
IMPORTANT: Before cleaning, turn off the unit
at the mains supply to avoid the shower being
accidentally switched on.
1 Rotate the spray plate clockwise until it
reaches it's 'stop' position facing the removal
button.
2 Press and hold the removal button in.
3 With the removal button held in, rotate the
face plate clockwise past the removal button
until it stops.
4 Release the removal button and gently pull
the face plate away from the body using the
adjustment lever.
IMPORTANT
Should any difficulty arise when trying
to remove the spray plate (image 4)
DO NOT try to force it out of the body
by hand, or by using tools such as a
screwdriver. Reset the spray plate to the
position shown in image 7 and repeat
steps 1-4 as listed above.
DO NOT remove the inner plate (image
4
5). Removing this, WILL invalidate any
product warranty.

8000 SERIES SHOWERHEAD
CLEANING
Triton recommends that all products are
cleaned using warm, soapy water.
DO NOT use abrasive or aggressive chemical
cleaning products as this may affect the
product surface and finish and invalidate your
guarantee.
NOTE: The showerhead can be cleaned quickly by
simply rubbing your fingers over the spray plate.
IT IS IMPORTANT TO KEEP THE SHOWERHEAD
CLEAN TO MAINTAIN THE PERFORMANCE
OF THE SHOWER. The hardness of the water
will determine the frequency of cleaning. For
example, if the shower is used every day in a
very hard water area, it may be necessary to
clean the showerhead on a weekly basis.
REPLACING THE SPRAY PLATE
5 The spray plate and face plate MUST be
aligned correctly for reinstallation. To align
them correctly, please do the following:
a Ensure that the inner plate is turned fully
clockwise until it stops. The alignment arrow
position is approximately 9 o'clock, when the
showerhead is in the vertical position.
b The lever MUST then be matched up with
the arrows position to reinstall the spray plate
correctly.
Should any difficulty arise when trying to
refit the spray plate DO NOT try to force
it back into position. Please make sure the
arrow and lever positions are correct.
Once in place, the spray plate face should be
gently pressed until its edges sit flush with
the body.
6 Now installed into the body, start to turn the
spray plate anti-clockwise.
7 To lock the plate back into the mechanism,
the spray plate MUST be rotated fully
anti-clockwise until it stops.
IMPORTANT: The showerhead should be
directed towards waste, and the shower
switched on to ensure the spray plate is
locked into the mechanism before use.
5
Inner plate
Alignment
arrow
a
Lever
matching
the arrow
position
b
6
7

SPARE PARTS
Ref. Description Part number
1. 5 mode rub clean showerheads
SHOWER HEADS
(mixer showers only)
88500060 ...................................WHITE MIXER
88500061 ................................CHROME MIXER
88500068 .....................................SATIN MIXER
(electric showers only)
88500062.................................INCLUSIVE WHT
88500069 .......................................ELEC SATIN
88500070 .........................INCLUSIVE CHROME
88500074 ......................................ELEC WHITE
88500075 ..................................ELEC CHROME
2. Flow Regulator
1
FLOW REGULATORS
22011740...............................................4 L/MIN
22011750...............................................5 L/MIN
22011760...............................................6 L/MIN
22011610...............................................7 L/MIN
22011280...............................................8 L/MIN
For latest service policy and contact details visit www.tritonshowers.co.uk
2