Tripp Lite SRX4, SRX2, SRX3 User Manual

SRX2, SRX3 and SRX4
Rack Mount Fixed And Roll-Out Shelves

CLIP NUT INSTALLATION

Clip Nuts provide mounting points for rack mount
fixed and roll-out shelves.

Clip nuts have a front or screw side. Consider which
way it should face for ease of access to the screw
head during component installation. (figure 1)

To remove a clip nut from a mounting angle, insert a flat
blade screwdriver or knife under the tab on the front and
pry up, freeing the retaining ring from the mounting
angle. (figure 2)

1. Select the location at which the shelf will be mounted
in the enclosure assembly.

2. Snap one clip nut into the top hole of the selected
location.
(note: When mounting a roll-out shelf, insert a
10-32 screw partially into each clip nut.)
If the weight load will exceed 75 lbs. on a roll-out shelf,
use four clip nuts and screws in each of the brackets.
It will be necessary to select a four-hole grouping that
matches the mounting holes in the brackets. The center
two holes will measure 1/2" apart.
Two screws per bracket, one at the front and one at the
rear, is sufficient if the weight load will be less than
75 lbs.

Rack Mount Fixed And Roll-Out Shelves

Clip nut

#10-32 x 5/8" Pan
Head Machine Screw

Front or screw side

Figure 1

Mounting angle

Clip nut

3. Measure from the bottom of the Mounting Angle to the
top clip nut. Assemble clip nuts onto the three other rails
at the measured height.

Manual Part #93-1937
01/18/02 rev. A

Figure 2

1

Lock nuts

SRX2 and SRX3
Rack Mount Fixed Shelves

Shelf bracket

FIXED SHELF INSTALLATION

1. Install the front and rear shelf brackets as
shown on both the left hand and on the
right hand side of the shelf.
(figure 3)

2. Align the shelf with the previously installed
clip nuts and attach the shelf with the 10-32
screws that are provided. Once the screws have
started in all four corners, tighten all of the screws.

FIXED SHELF ADJUSTMENT

1. To adjust the Fixed Shelf, loosen the bracket screws,
move the brackets, then re-tighten the screws.
(figure 5)

Figure 3

Clip nuts

#10-32 x 5/8" Pan
Head Machine Screws

#10-32 x 3/8" Phillips
Pan Head Screws

Fixed shelf

Bracket

Figure 4

Manual Part #93-1937
01/18/02 rev. A

Shelf brackets

Screws

Figure 5

2