Triax THS 1X2D4K User Manual

User Manual

THS 1x2D4K

HDMI 2.0 1x2 Splitter with 4K to 1080P

Down-scaling

Product Code : 310074

Statement

Thank you for purchasing this product. Please read this user manual carefully before
use. We reserve the right to make changes to the product without notice.

Safety Precaution

 Do not dismantle the housing or modify the module.

 Do not expose the unit to rain, moisture or install this product near water.

 Install the device in a place with good ventilation.

 Do not use liquid or aerosol cleaners to clean this unit.

 Always unplug the power to the device before cleaning.

 Unplug the power when not used for a long period of time.

 Refer all servicing to qualified personnel.

After-sales Service

Please contact your point of purchase for details of the warranty supplied.

Packing List

 1x HDMI 2.0 1x2 Splitter

 4x Plastic pads

 1x Power Adapter (5V DC 1A)

 1x User Manual

Product Introduction

Thank you for choosing the HDMI 2.0 1x2 Splitter, which can distribute one HDMI input
to two outputs. The splitter supports HDMI video resolution up to 4K@60Hz 4:4:4,
1080P 3D, and multichannel audio formats. It also passes the EDID information from
the display, The multiple built-in EDID settings can be selected by the 4-pin DIP switch
on the front panel. The splitter supports convenient firmware upgrade through Micro­USB port.

2

123

4

12345

Features

 Supports HDMI 2.0 and the video resolution up to 4K@60Hz 4:4:4.

 HDMI input supports HDCP 2.2 and the outputs support HDCP Active or HDCP

Passive mode.

 Supports video resolution down-scaling, the 4K input can be automatically

degraded to 1080P output for compatibility with 1080P display.

 18Gbps high bandwidth.

 Advanced EDID management: multiple built-in EDID settings can be selected.

 Built-in equalizer for signal enhancement to avoid signal attenuation in

transmission.

 Supports CEC pass-through.

 Provides LEDs to indicate the current operating status.

 Firmware upgrade by Micro-USB port.

Panel Description

Front Panel

INFW1 2

ON

OF F

EDI D

1
0

POWER LED: The LED illuminates red when power is applied.

①

INPUT LED: The LED illuminates blue when there is HDMI input.

②

OUTPUT LEDs: The LED illuminates blue when there is HDMI output on the

③

corresponding channel.

EDID: 4-pin DIP switch for EDID setting and HDCP mode selection. Please refer to

④

the EDID Management for more details.

FW: Micro-USB port for firmware upgrade.

⑤

Rear Panel

3