Trendnet TPE-S160 QUICK INSTALLATION GUIDE [no]

Guia de Instalação Rápida

TPE-S160

1.01

Índice

Português 1

1.

Antes de Iniciar 1

2.

LEDs 2

3. Instalação de Hardware 3

Technical Specifications 7
Troubleshooting 8

Version 02.16.2010

1. Antes de Iniciar

Conteúdo da Embalagem

ŸTPE-S160

Português

Requisitos Mínimos do Sistema

ŸComputador com adaptador de rede instalado
ŸCabo de rede RJ-45
ŸSuperfície deve suportar no mínimo 3.8 kg (8.4 lb)
ŸA tomada elétrica deve estar a no máximo 1,82 metros do Switch.
ŸAssegure-se de que há ventilação adequada e dissipação de calor aproriada no

entorno do Switch.

ŸNão coloque objetos pesados sobre o Switch.
ŸDispositivo Alimentado IEEE 802.3af

Equipamento opcional

ŸGuia de Instalação Rápida Multilínguas
ŸCabo de Alimentação (1.8m / 6ft)
ŸKit de Montagem em Rack

ŸTPE-112GS (Opcional)
ŸRack padrão EIA 19” (Opcional)

Nota:
O TPE-S80 somente suporta Dispositivos acionados que seguem o padrão
IEEE 802.3af.

1

2. LEDs

Device Status LED

Color

Sequence

Definition

PoE
(Power over Ethernet)

Power

Link/ACT

Ambar

Estático

Estático

Estático

Piscando

Ambar

Verde

N/A

Desligado

Desligado

Desligado

N/A

N/A

PoE device is connected
Nenhum dispositivo está conectado

Não há conexão na porta

Dispositivo ligado
Dispositivo desligado

Conectado 10/20 Mbps (Half/Full Duplex)
ou 100/200 Mbps (Half/Full Duplex)
(por porta)

Transmissão/Recepção de Dados
10/20 Mbps (Half/Full Duplex) ou
100/200 Mbps (Half/Full Duplex)

Link/ACT

PoE (Power over Ethernet)

Power

2

PORTUGUÊS

3. Instalação de Hardware

1. Conecte o Cabo de Alimentação ao TPE-S160

e então a uma tomada elétrica.

Português

2. Mova a chave de Power para a posição ON.

3. Conecte um cabo de rede RJ-45 do

computador a uma porta Ethernet disponível no
TPE-S160.

3

4. Conecte um cabo RJ-45 de uma porta PoE do
TPE-S160 à porta LAN do dispositivo PoE
(explo TEW-638PAP).

5. Verifique se as seguintes luzes no painel estão
acesas: Power, PoE e LINK/ACT.

PORTUGUÊS

4

Utilizando dispositivo não PoE com o TPE-S160 e o TPE-112GS

Nota: Anote a tensão de saída de seu dispositivo não PoE. O TPE-112GS somente
suporta dispositivos não PoE com tensão de saída de 5 V, 7,5 V, 9 V ou 12 V.

Português

1. Selecione a tensão adequada (5 V, 7,5 V, 9 V

ou 12 V).

2. Conecte um cabo Ethernet de uma porta PoE
do switch TPE-S160 à porta "PoE IN" do
TPE-112GS.

3. Conecte um cabo Ethernet da porta "Data-Out"
do TPE-112GS à porta LAN do dispositivo não
PoE (explo TEW-639GR).

4. Conecte o cabo jumper fornecido ao dispositivo

não PoE (explo: TEW-639GR) e ao
TPE-112GS.

5. Verifique se as seguintes luzes no painel estão

acesas: POWER, PoE e LINK/ACT.

5

Montagem em Rack

O switch pode ser montado em rack de 19 polegadas padrão EIA, o qual pode ser
colocado num armário com outro equipamento.

1. Coloque as cantoneiras em ambos os lados do
chassi e fixe-as com os parafusos fornecidos
no kit.

2. Com cuidado posicione o chassi no rack. Alinhe
as cantoneiras aos orifícios do rack, então use
os parafusos fornecidos com o equipamento
para montar o chassi.

PORTUGUÊS

6

Technical Specifications

Hardware

Standard

ŸIEEE 802.3 10Base-T
ŸIEEE802.3u 100Base-TX
ŸIEEE 802.3af Power over Ethernet
ŸIEEE 802.3x Flow Control

16 x 10/100Mbps Auto-MDIX PoE ports

On/Off power switch

ŸEthernet: 10/20Mbps (half/full duplex)
ŸFast Ethernet: 100/200Mbps (half/full duplex)

1.5Mbits

4K MAC entries

3.2Gbps

100~240VAC 50/60Hz, internal universal switching power

Power, Link/Activity, PoE Act/Status

Ÿ6 Watts max. (no Power Device (PD) connected)
Ÿ260 Watts max. (16 PoE devices connected)

ŸOperating: 0° ~ 45°C (32° ~ 113°F)
ŸStorage: -10° ~ 70°C (14° ~ 158°F)

Ports

Power Switch

Data Transfer Rates

Data RAM Buffer

Address Table

Switch Fabric

Power

Diagnostic LEDs

Power Consumption

Temperature

10%- 95% (non-condensing)

440 x 220 x 44 mm (117.3 x 8.7 x 1.7 in.)

3.1 kg (6.9 lb)

CE, FCC

ŸUp to 15.4 watts per port; PD classification
ŸPolymer switch for short protection
ŸPoE: pin 3,6 for power (+) and pin 1,2 for power

Humidity

Dimensions

Certifications

Weight

PoE

Power over Ethernet

7

Troubleshooting

1. Depois de conectar o Switch a uma tomada elétrica, os LEDs não acendem.

1. Verifique a conexão do cabo de alimentação ao TEG-S160Dg e à tomada.

2. Certifique-se de que o botão Power esteja na posição On.

3. Verifique se a tomada utilizada está alimentada.

2. Após conectar meus PCs ao Switch, eu não consigo compartilhar arquivos.

1. Verifique os LEDs no Switch. Certifique-se de que o LED Link/ACT LED está
aceso.

2. Verifique os cabos de rede. O comprimento mínimo do cabo é 1,50 metros e o
máximo é 100 metros.

3. Desabilite qualquer software de firewall.

4. Confirme que o compartilhamento de arquivos está habilitado. Favor contactar
o suporte de seu sistema operacional para mais informações.

3. Após conectar meus PCs ao Switch, eu consigo acessar a Internet apenas por
um computador.

O Switch não é projetado para compartilhar Internet entre vários computadores.
Você precisa de um roteador internet como o TW100-S4W1CA.

4. Meu Dispositivo Acionado 802.3af não liga quando eu plugo o dispositivo no
Switch. O que devo fazer?

1. Verifique se o dispositivo PoE suporta o protocolo IEEE 802.3af.

2. Certifique-se de que a chave "Power" esteja na posição "on".

3. Reinicie o switch PoE. Desconecte o Switch da tomada, aguarde 15 segundos,

então conecte a tomada novamente.

4. Plugue o dispositivo em uma porta diferente do switch PoE.

5. Tente usar outro cabo de rede RJ-45.

5. Onde está localizada a porta uplink do Switch?

Uma vez que todas as portas são Auto-MDIX, qualquer das portas pode ser

utilizada para uplink.

Se você ainda encontrar problemas ou tiver alguma pergunta referente ao TPE-S160
favor entrar em contato com o Departamento de Suporte Técnico da Trendnet.

8

Limited Warranty

TRENDnet warrants its products against defects in material and workmanship, under normal
use and service, for the following lengths of time from the date of purchase.

TPE-S160 – 3 Years Limited Warranty

AC/DC Power Adapter, Cooling Fan, and Power Supply carry a 1 year warranty.

If a product does not operate as warranted during the applicable warranty period, TRENDnet
shall reserve the right, at its expense, to repair or replace the defective product or part and deliver
an equivalent product or part to the customer. The repair/replacement unit's warranty continues
from the original date of purchase. All products that are replaced become the property of
TRENDnet. Replacement products may be new or reconditioned. TRENDnet does not issue
refunds or credit. Please contact the point-of-purchase for their return policies.

TRENDnet shall not be responsible for any software, firmware, information, or memory data of
customer contained in, stored on, or integrated with any products returned to TRENDnet
pursuant to any warranty.

There are no user serviceable parts inside the product. Do not remove or attempt to service the
product by any unauthorized service center. This warranty is voided if (i) the product has been
modified or repaired by any unauthorized service center, (ii) the product was subject to accident,
abuse, or improper use (iii) the product was subject to conditions more severe than those
specified in the manual.

Warranty service may be obtained by contacting TRENDnet within the applicable warranty
period and providing a copy of the dated proof of the purchase. Upon proper submission of
required documentation a Return Material Authorization (RMA) number will be issued. An
RMA number is required in order to initiate warranty service support for all TRENDnet
products. Products that are sent to TRENDnet for RMA service must have the RMA number
marked on the outside of return packages and sent to TRENDnet prepaid, insured and
packaged appropriately for safe shipment. Customers shipping from outside of the USA and
Canada are responsible for return shipping fees. Customers shipping from outside of the
USA are responsible for custom charges, including but not limited to, duty, tax, and other
fees.

9

WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS
WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S
OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE
EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED,
EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
TRENDNET NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME
FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION
MAINTENANCE OR USE OF TRENDNET'S PRODUCTS.

TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND
EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT
EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT,
IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR
MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY
ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD.

LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO
EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN
CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL,
INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE
OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER
FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION,
MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE
POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR,
REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDNET'S OPTION.
THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY
REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.

Governing Law: This Limited Warranty shall be governed by the laws of the state of California.

Some TRENDnet products include software code written by third party developers. These codes

are subject to the GNU General Public License ("GPL") or GNU Lesser General Public License

("LGPL").

http://www.trendnet.com/gpl http://www.trendnet.com

Go to or Download section and look for
the desired TRENDnet product to access to the GPL Code or LGPL Code. These codes are
distributed WITHOUT WARRANTY and are subject to the copyrights of the developers.
TRENDnet does not provide technical support for these codes. Please go to

http://www.gnu.org/licenses/gpl.txt http://www.gnu.org/licenses/lgpl.txt

each license.

or for specific terms of

10

Copyright ©2011. All Rights Reserved. TRENDnet.