TRENDnet TEW-755AP2KAC V1, TEW-755AP2KAC, TEW-821DAP2KAC, TEW-821DAP2KAC V1 Quick Installation Manual

TEW-755AP2KAC (V1) / TEW-821DAP2KAC (V1)

Quick Installation Guide

Table of Content

1 English

1. Before You Start

2. Hardware Installation and Configuration

3. Connect your wireless access points

ENGLISHFRANÇAISDEUTSCH

ESPAÑOLРORTUGUÊS

1

1. Before You Start

Package Contents

Ÿ 1 x TEW-WLC100 wireless LAN controller
Ÿ 2 x TEW-755AP N300 PoE access points or TEW-821DAP AC1200 dual band PoE access

points

Ÿ 2 x TPE-113GI 802.3af Gigabit PoE injectors
Ÿ 2 x Network cables (1.5 m / 5 ft.)
Ÿ TEW-WLC100 power adapter (12V DC, 1A)
Ÿ Quick Installation Guide
Ÿ CD-ROM (User's Guide)
Ÿ Controller rack mount kit
Ÿ Access point mounting plates

Minimum Requirements

Ÿ Computer with an Ethernet port and web browser
Ÿ Network cable for computer connection to controller
Ÿ Network cables for access point connections to PoE injectors

Important Note: Make sure your existing network is using a DHCP server to distribute IP
addresses to the access points. By default, TRENDnet access points listed below will obtain an IP
address automatically through DHCP or otherwise default back to 192.168.10.100 /

255.255.255.0 if a DHCP server is not available on your network. Each access point must be
assigned a unique IP address on the same network. The wireless controller and access points
must be connected to the same IP subnet on your network (e.g. 192.168.10.x / 255.255.255.0).

Optional Equipment

Ÿ EIA standard 19” rack
Ÿ Power drill/drill bits and Phillips bit or screwdriver for mounting

2

Access Point Model

Description Controller Compatible

Firmware Version

TEW-755AP N300 PoE Access Point 1.03 or above

TEW-821DAP AC1200 Dual Band PoE Access Point 1.05 or above

TEW-825DAP AC1750 Dual Band PoE Access Point 1.01 or above

Access Point Compatibility

By default, the access points included in this kit are controller ready. For any additional access
points, please refer to the access point model compatibility list below and controller compatible
firmware version. You can download the access point's firmware from
http://www.trendnet.com/support which include instructions on how to upgrade the firmware.

Before any additional access points are added to the wireless controller, make sure to reset the
access points to factory default.

ENGLISHFRANÇAISDEUTSCH

ESPAÑOLРORTUGUÊS

3

2. Initial Controller Setup

3. Assign a Static IP address to your computer's network adapter in the subnet of 192.168.10.x
(e.g. 192.168.10.25) and a subnet mask of 255.255.255.0.

4. Open your web browser, type the default IP address of the wireless controller in the address
bar, and then press Enter. The default IP address is 192.168.10.200.

Note: Before connecting the wireless controller to the network and connecting other devices
such as PoE injectors or access points, follow the steps to set up your controller IP address
settings and administrator password first.

1

Power

2