Quick Installation Guide
TEW-687GA
1.01
Table of Contents
English 1
1. Before You Start
2. Hardware Installation 2
3. Configure the TEW-687GA 4
4. Wi-Fi Protected Setup (WPS) Push Button Setup 8
Troubleshooting 10
Wireless Tips 12
1
Version 01.04.2011
1. Before You Start
Package Contents
TEW-687GA
Ÿ
ŸCD-ROM (User's Guide)
ŸMulti-Language Quick Installation Guide
ŸPower Adapter (12V DC, 0.5A)
ŸNetwork Cable (0.6m/2ft.)
System Requirements
A computer with network adapter installed
Ÿ
ŸWireless router (e.g. TEW-691GR) or access point (e.g TEW-690AP)
ŸAn available DHCP Server – wireless routers usually have a built-in DHCP server
ŸA media device (e.g. Blu-ray player, Internet-ready TV, etc.) or game console with
an Ethernet port
ŸWeb Browser: Internet Explorer (6.0 or higher)
1
2. Hardware Installation
Note:
1. Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or
access point. If you would like to use WPS push button setup, please go directly to
section 4. Wi-Fi Protected Setup (WPS) Push Button Setup. If your wireless router or
access point does not support WPS, continue on to step 1.
2. Do not connect/install the TEW-687GA to your network until instructed to do so. Make
sure your computer's network adapter settings are set to obtain an IP address
automatically (see troubleshooting section).
1. Connect one end of the provided RJ-45 network
cable to the TEW-687GA's LAN port. Connect
the other end of the cable to your computer's
network port. Then boot up your computer.
2. Connect the Power Adapter to the TEW-687GA
and then to a power outlet. (EU versions will
have a power button on the back. Push the
power button to the “On” position). Wait 30
seconds for the TEW-687GA to boot up.
2
3. Verify that the following panel lights are on:
Power, Network Port, and Wireless.
Wireless (Blue/Blinking)
Network Port (Blue/Blinking)
Power (Blue/Solid)
3
3. Configure the TEW-687GA
1. Open your web browser, type
http://TEW-687GA.trendnet in the Address bar,
and then press Enter.
Enter the User Name and password and then
2.
click OK. Default Settings:
User name: admin
Password:
Note: User name and Password are case
sensitive.
3. The Wizard will automatically appear. Click
Administration Ž Wizard if the Wizard does
not automatically appear.
admin
4. Click Next.
4
5. Select DHCP Client to have the TEW-687GA
automatically obtain an IP address from your
DHCP server (router).
If Static IP address is selected you would need
to configure the following:
IP address: The assigned IP address should
match your network. This IP address should
not be used by any other network device on
your network.
Subnet Mask: In most cases, the default
Subnet Mask (255.255.255.0) should be fine.
Default Gateway: Enter the IP address of your
router for the Default Gateway.
Then click Next.
Note: It is recommended to manually configure
the LAN Interface Settings (IP address, Subnet
Mask, Default Gateway) in case you need to
access the device in the future. Please write
down the IP settings for future reference.
6. Select Manual Setup and then click Next.
7. Click Scan.
8. Select a SSID and then click Select. The SSID
is the wireless network name of your wireless
network (e.g. wireless router or access point).
9. Click Next.
5
Loading...