Trendnet TEW-676APBO User Manual
N300 Wireless 12dBi Outdoor 5GHz PoE
Access Point
TEW-676APBO
ŸQuick Installation Guide (1)
TEW-676APBO (V1.0R) / 03.07.2012
1. Before You Start
Package Contents
Ÿ
TEW-676APBO
Ÿ
CD-ROM (User's Guide)
Ÿ
Multi-Language Quick Installation Guide
Ÿ
PoE Injector
Ÿ
Power Cord
Ÿ
Mounting Hardware
Ÿ
Waterproof Kit
Ÿ
Grounding wire
Note: The TEW-676APBO does not support IEEE 802.3af. You must use the special Power over
Ethernet injector that is supplied with the TEW-676APBO.
Minimum Requirements
Web Browser: Internet Explorer (6.0 or
Ÿ
above)
A computer with a network adapter properly
Ÿ
installed
A network Switch or Router with an
Ÿ
available network LAN port
2 x RJ-45 network cables
Ÿ
Phillips screwdriver
Ÿ
2. How to Install
Connecting the Grounding Wire
1. Remove the screw and washer from the grounding hole using a screwdriver. This is located on the
bottom of the TEW-676APBO.
2. Align one end of the grounding wire over the hole. Then connect the screw and washer back in.
3. Connect the green grounding wire to a grounding object. e.g. Earth Driven rod, Grounded Electrical
System, Building Frame.
1
Connecting the Ethernet Cable
1. Unscrew the sealing nut from the cable gland.
2. Separate the rubber seal from the claw.
3. Verify that you have the following parts: Cable Gland, Seal, Claw, Sealing Nut.
Cable Gland Seal Claw Sealing Nut
4. In the following order insert one end of an Ethernet cable into the sealing nut, seal/rubber, claw and
finally through the cable gland.
5. Connect the Ethernet Cable to the PoE port on the rear of the TEW-676APBO.
6. Using your hand, screw the seal nut counter clockwise to secure it to the cable gland.
2
Loading...