Table of Contents
Table of Contents
English ......................................................................................................
1. Before You Start
2. Hardware Installation .........................................................................
3.
Configure the TEW-654TR ................................................................
Troubleshooting ........................................................................................
.................................................................................
1
1
3
5
9
Version 06.16.2009
1. Before You Start
Package Contents
TEW-654TR
?
CD-ROM (User’s Guide)
?
Multi-Language Quick Installation
?
Guide
Travel case
?
USB to power-pin cable
?
(0.45m/2.5ft.)
Cat. 5 Ethernet cable (1.1m/3.6ft.)
?
Power adapter (5V, 1.2A)
?
Installation Requirements
?
A computer with a wireless network adapter properly installed
?
Web Browser: Internet Explorer (6.0 or higher)
?
Broadband Internet
Installed Cable or DSL Modem
?
Note: For AP and AP Client mode instructions, please refer to the
troubleshooting section and User's guide.
1
English
2. Hardware Installation
S/N:
TEW-654TR H/W:V1.0R
FCC ID: S9Z TEW654TR
0470
CA09210122334
Note:
1. Gather all information related to your Internet Connection before you start. If
necessary, contact your Internet Service Provider (ISP).
2. The below steps is for router mode configuration. For AP and client mode
instructions, please refer to the User's Guide.
1. Verify that you have an Internet
connection when connecting your
computer directly to the Cable or
DSL modem or Ethernet jack. Open
your browser (e.g. Internet
Explorer) and type in a URL (e.g.)
in the address bar.
2. Move the switch on the bottom of
the TEW-654TR to RT mode.
Internet
Cable/DSL Modem
3. Connect one end of the provided
RJ-45 cable to the TEW-654TR's
LAN port. Connect the other end
of the cable to your modem or
Ethernet jack (e.g. in a hotel room).
3
English
4. Connect the AC Power Adapter to
the wireless router and then to a
power outlet.
5. Verify that the following panel lights
are on: POWER, LAN and WLAN.
6. Press the WPS button on the
TEW-654TR for 5 seconds, then let
go. The WLAN LED will be blinking
amber.
7. Follow the WPS push button setup
instructions for your Wireless
Adapter's configuration utility to
connect to the TEW-654TR.
4
English