Quick Installation Guide
TEG-PCBUSR
Table of Contents
Table of Contents
Deutsch .....................................................................................................
1. Bevor Sie anfangen ...........................................................................
2. Installation .........................................................................................
Troubleshooting ........................................................................................
1
1
2
3
Version 07.06.2006
1. Bevor Sie anfangen
Systemanforderungen
CD-ROM-Laufwerk
Steckplatz für CardBus PC-Karte Typ II
Prozessor: Intel Pentium 300 MHz oder schneller
Speicher: 64 MB RAM oder mehr
Windows 98SE/ME/2000/XP
Anwendung
32-Bit Gigabit CardBus PC Card
(TEG-PCBUSR)
Packungsinhalt
TEG-PCBUSR
Treiber-CD
Anleitung zur Schnellinstallation
32-bit 10/100/1000Mbps
Copper Gigabit PCI Adapter
(TEG-PCITXR)
5-Port 10/100/1000Mbps
Copper Gigabit Switch
(TEG-S50TXE)
32-bit 10/100/1000Mbps
Copper Gigabit PCI Adapter
1
Deutsch
(TEG-PCITXR)
2. Installation
Hinweis: Die TEG-PCBUSR ist während des Betriebs an- und absteckbar
(„hot-pluggable“), Sie können sie also anschließen oder entfernen, während
der Computer eingeschaltet ist.
1. Der Found New Hardware Wizard
(Assistent „Neue
Hardwarekomponente gefunden“)
erscheint. Markieren Sie No, not
this time (Nein, jetzt nicht) und
klicken Sie dann auf Next Weiter).
2. Legen Sie die Treiber-CD in das
CD-ROM-Laufwerk Ihres
Computers.
3. Legen Sie die CD-ROM in das CD-
ROM-Laufwerk ein, markieren Sie
Install the software
automatically (Recommended)
(Software automatisch installieren
(empfohlen)) und klicken Sie dann
auf Next (Weiter).
3. Klicken Sie auf Finish
(Fertigstellen).
Ihre Installation ist beendet!
Weitere Informationen zu den Konfigurations- und erweiterten Einstellungen
des TEG-PCBUSR finden Sie auf der Website von Trendnet unter
http://www.trendnet.com.
2
Deutsch
Troubleshooting
Q1:
Windows is unable to recognize my hardware. What should I do?
A1:
First, verify that your computer meets the system requirements as specified in
Section 1. Second, go to Start -> Control Panel -> Hardware -> Device
Manager. In the list of device types, double-click on Network Adapters. If you
see the device with a yellow question mark or exclamation point next to it, doubleclick on it, click on Drivers and click Update Drivers. Follow the Hardware
Update Wizard instructions as illustrated in Section 2. Third, if the device
manager fails to recognize the presence of a new networking adapter, verify that
the network adapter is firmly seated in the PC CardBus slot. Fourth, install the
adapter into another available PC CardBus slot
Windows recognizes my new hardware, but I'm unable to connect to my
Q2:
network. What should I do?
First, verify that the RJ-45 Ethernet Cable is securely connected from your
A2:
switch or router to your network adapter. Second, verify that the LEDs on your
network card are lit. Third, verify that the TCP/IP settings are set to Obtain an IP
address automatically.
When I connect the adapter to a gigabit switch, I am not getting gigabit
Q3:
speeds. What should I do?
Make sure you are using CAT-5e or CAT-6 Ethernet Cables. Some CAT-5
A3:
cables are not rated to run in Gigabit.
If you still encounter problems or have any questions regarding the TEG-PCBUSR,
please refer to the User's Guide included on the Driver CD-ROM or contact TRENDnet's
Technical Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may cause
undesired operation.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
3
TRENDnet Technical Support
.
US Canada
Toll Free Telephone: 1(866) 845-3673
24/7 Tech Support
Europe (Germany France Italy Spain Switzerland UK)
Toll Free Telephone: +00800 60 76 76 67
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
. . . . .
Worldwide
Telephone: +(31) (0) 20 504 05 35
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com
3135 Kashiwa Street
Torrance, CA 90505
USA
Copyright ©2006. All Rights Reserved. TRENDnet.
Loading...