Transition Networks E-100BTX-FRL-01, E-100BTX-FRL-01SC, E-100BTX-FRL-01SM User Manual

The TRANSITION Networks Ethernet™ 100BASE-TX to 100BASE-FX media converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX multimode or singlemode fiber-optic cable. Media converter models are selected according to the fiber mode and fiber connector required at the site. Multimode fiber-optic cable can use either an ST connector (E-100BTX-FRL-01) or an SC connector (E-100BTX-FRL-01(SC)). Singlemode fiber (E-100BTX-FRL-01(SM)) uses only an SC connector. All media converters function in half-duplex mode or, when connected to devices capable of full-duplex connectivity, in full-duplex mode.

Minneapolis, MN 55344 USA

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Compliance Information

UL Listed C-UL Listed (Canada) CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

© 1996, 1997 TRANSITION Networks. All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners. 33009.C

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

MEDIA CONVERTER TECHNICAL SPECIFICATIONS

Standards IEEE 802.3 Case dimensions 3.9" x 3.0" x 1.0" (99mm x 76mm x 25mm)

Environment Temperature: 0-40°C (32° to 104° F )

Humidity 10-90%, non condensing Altitude 0-10,000 feet

Warranty Five years

100BASE-TX/100BASE-FX Media Converters

E-100BTX-FRL-01, E-100BTX-FRL-01(SC), E-100BTX-FRL-01(SM)

USER’S GUIDE

Pwr (Power) Illuminated green LED

indicates connection to external AC power.

RX (Receive) Flashing green LED

indicates port is receiving data.

Link Steady green LED indicates port is

receiving link signal.

Status LEDs on the connector side of the media converters provide the following information:

10BASE-T

ST Connectors

Link

Pwr

(Fiber)

Link

RJ-45 Connector

10BASE-T

10BASE-FL

SC Connectors

Link

Pwr

RJ-45 Connector

10BASE-T

10BASE-FL

Pwr

Link

(RJ-45)

Power Supply Requirements Replace power supply with only the equivalent input

rating (see below) and output rating (regulated 9VDC at 0.5 A).

TN PN

Requirement Location 3517 240 volts, 50 hertz United Kingdom 3516 230 volts, 50 hertz Europe 3518 120 volts, 60 hertz USA/Canada/Mexico 3514 100 volts, 50-60 hertz Japan 3515 240 volts, 50 hertz Australia

E-100BTX-FRL-01

Provides an RJ-45 unshielded twisted pair 100BASE-TX connector and a set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to multimode fiber-optic cable.

E-100BTX-FRL-01(SC)

Provides an RJ-45 unshielded twisted pair 100BASE-TX connector and an RX (receive) and TX (transmit) SC 100BASE-FX connector to multimode fiber-optic cable.

E-100BTX-FRL-01(SM)

Provides an RJ-45 unshielded twisted pair 100BASE-TX connector and an RX (receive) and TX (transmit) SC 100BASE-FX connector to singlemode fiber-optic cable.

E-100BTX-FRL-01

E-100BTX-FRL-01(SC)

(SM)

E-100BTX-FRL-01(SM)

UTP

Multimode Fiber

UTP

Multimode Fiber

UTP

Singlemode Fiber