Trango Systems PTZ900TX User Manual

PTZ-900 Series

______________________________________________________________________________________

900 MHz Spread Spectrum
Digital Wirele ss Pan/Tilt/Zoom Camera Control Transmission S ystem

Installation and Operating Instructions

Your Trango Systems Wireless PTZ System:

ongratulati ons on choosing

C

missing, notify your sales representative. If an item appears to be damaged from shipment, replace it in its packing material and notify
the shipper.

Save the packaging for further storage of the equipment.

Trango Systems, Inc.

to fulfill your wireless needs. Unpack your system carefully. If any items are

Service:

f the unit ever needs repair service, contact Trango Systems customer service f o r r eturn authorization and shipping instructio ns.

I

Note: This equipment generates, uses, and can radiate radio fr equency energy, and if not installed and used in accordance
with these instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by
one of more of the following meaures:

1) Reorient the receiving antenna;

2) Increase the separation between the affected equipment and the receiver;

3) Connect the affected equipment to an outlet on a different circuit from that
which the receiver is connected to;

4) Consult the dealer and/or experienced radio/T V technic ian for help.

FCC ID Numbers:

Transmitter PTZ-900TX: FCC ID# NCYPTZ900TX

WARNING

compliance must not be made. Any such modifications could void the user’s authority to operate the equipment.

: Intentional or unintentional changes or modificatio ns not expressly approved by the party responsible for

QUICK START GUIDE

1. VERIFY PROPER OPERATION OF CAMERA CONTROL US ING A DIRECT WIRED
CONNECTION PRIOR TO INSTALLING WIRELESS LINK.

2. SET THE PTZ-900TX AND PTZ-900RX SERIAL PORT DATA RATE AND MODE (RS422 or
RS232) USING THE TRANGOLINK PROGRAM AND SUPPLIED CABLE. (

REQUIRED IF THE PTZ CONTROL EQUIPMENT IS SET TO USE 9600 BPS and RS422 or
RS485 MODE

3. INSTALL TRANSMITTER AND RECEIVER UNITS IN DESIRED LOCATION TO 2 3/8”
MAX DIAMETER STEEL POLE PER INSTALLATION DRAWING.

4. INSTALL ANTENNAS ABOVE THE ENCLOSURES AND ALIGN PROPERLY.

IMPORTANT NOTE: THE PTZ-900TX (TRANSMITTER) USES A SPECIAL ANTENNA
CONNECTOR. ONLY USE ANTENNAS SUPPLIED BY TRANGO SYSTEMS WITH THIS TYPE
OF CONNECTOR OR DAMAGE TO THE UNIT MAY OCCUR.

5. TIGHTEN ANTENNA CABLE TO REC EIVER AND TRANSMITTER. APPLY A SM ALL
AMOUNT OF SILICONE TO FLANGE TO MAKE A LEAKPROOF CONNECTION.

)

THIS STEP NOT

6. CONNECT INTERFACE AND POWER CABLE S TO UNITS THROUGH FLANGES.
TIGHTEN FLANGES TO ALLOW SMALL A IR GAP AT BOTTOM OF ENCLOSURE.
MAKE SURE THAT GROUNDING STRAP IS SECURE TO AN EARTH GROUND.

7. VERIFY THAT LEDs ARE SOLID R ED ON TRANSMITTER AND RECEIVER BEFORE
SENDING PTZ COMMANDS.

8. TIGHTEN LID OF ENCLO SURE DOWN.

IMPORTANT NOTE: DO NOT APPLY POWER TO THE TRANSMITTER UNLESS THE
ANTENNA IS CONNECTED. PERMANENT DAMAGE MAY RESULT.

SAFETY NOTE: THE PTZ-900TX TRANSMITTER OUTPUT POWER VARYS BETWEEN ½
and 4 WATTS EIRP. ALTHOUGH TRANSMISSIONS ARE OF A SHORT DURATION, IT IS
RECOMMENDED THAT THE TRA N SMIT ANTENNA BE KEPT AT LEAST 3 FEET AWAY
FROM NEARBY PERSONS.