Trango Systems M5800SBSUEXT User Manual

MODEL M5800SB-SU-EXT

5.8 GHz Digital Spread Spectrum Wireless Internet Subscriber Unit

Installation and Operating Instructions

SUNSTREAM WIRELESS, A DIVISION OF TRANGO SYSTEMS, INC.

1•Setup transceiver per instructions herein before installing outdoors. 2•Mount the dish antenna to a wall or earth grounded mast 1.5 to 2.5 inches in diameter. 3• Install transceiver to dish antenna mounting arm. The pole must be securely mounted so

that it does not move, and may be from 1.5” to 3” in diameter.

WARNINGWARNING

USE EXTREME CARE WHEN INSTALLING ANTENNAS NEAR POWER LINES.

4• Slide heatshrink over antenna cables. Tighten right angle connectors to transceiver and

straight connectors to antenna feed element. Use a 5/16 inch open ended wrench to tighten the connectors until snug. Do not overtighten. Heat the heatshrink until it contracts around the connector junction.

5• Construct or puchase a shielded twisted pair (STP) cat 5 straight through 8 conductor

Ethernet cable terminated with shielded RJ45 connectors long enough to go along the pole or wall to the building entry point. Use conduit and a drip loop as appropriate per National Electrical Code.

6• Connect the cable to the unit and tighten the flange around the cable or conduit. 7• Install the junction box indoors near the entry point into the building. Plug the Ethernet

cable going to the transceiver into the ODU port (above the power input). Plug the wall mount 20 V adapter into the wall and then into the power input. Verify that both LEDs come on solid after approximately 30 seconds.

8• Align the antenna by moving it left to right, then up and down. Theblink rate of the

yellow LED viewable through the Access Door will increase and ultimately go solid if the signal is strong enough. If the LED is not glowing no signal is being received from the Access Point. Verify that the Green LED blinks occasionally to indicate packets being received from the Access Point.

9• Tighten all nuts and bolts down after the alignment is completed. 10• To help protect against potential lightning damage, use an ethernet lightning surge

arrestor in line with the STP cable at the entry point to the building.

CAUTIONCAUTION

DO NOT APPLY POWER TO THE TRANSMITTER UNLESS THE ANTENNA IS CONNECTED. PERMANENT DAMAGE MAY RESULT.

Thank you for choosing Sunstream Wireless to fulfill your wireless internet access needs.

Unpack your system carefully. If any items are missing, notify your sales representative. If an item appears to be damaged from shipment, replace it in its packing material and notify the shipper. The subscriber kit contains the following items packaged in three boxes:

- 1 transceiver unit

- 2 mounting brackets

- 4 nuts for mounting brackets

- 1 Junction box

- 1 power adapter

- 1 Dish antenna (24 inch width)

- 2 coaxial cables

- 1 dish antenna feed element

- 1 warranty card

Service:

If the unit ever needs repair service, contact your service provider or Sunstream Wireless distributor as appropriate for return authorization and shipping instructions.

FCC Information:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with these instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of more of the following measures:

1) Reorient the antenna;

2) Increase the separation between the affected equipment and the unit;

3) Connect the affected equipment to an outlet on a different circuit from that which the receiver is connected to;

4) Consult the dealer and/or experienced radio/TV technician for help.

FCC ID: NCYM5800SBSUEXT

CANADA: Pending

IMPORTANT NOTE: Intentional or unintentional changes or modifications not expressly approved by the party responsible for compliance must not be made.

Any such modifications could void the user’s authority to operate the equipment and will void the manufacturer’s warranty.

IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the following antenna installation and device operating configurations must be satisfied – The antenna for this unit must be fixed-mounted on outdoor permanent structures with a separation distance of at least 2 meters from all persons and must not be co-located or operating in conjuction with any other antenna or transmitter.

+ 7 hidden pages

Trango Systems M5800SBSUEXT User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual