Trail Tech D112-SS User Manual

Dual 70mm LED Light Harness Installation

SPECIFICATIONS:

• Brightness Modes: High > Low

• Power Draw: 30W / 15W

• Lumens: 2500 / 1250 (High/Low Mode)

• Mounting: Solid Post

• Housing Material: Rugged Billet Aluminum

• Housing Color: Black

• Size: 71x97mm (2.8 x 3.8in)

• Weight: 460g (16.2 oz.)

• Front Lens: Hardened Glass

• Beam Color: 6000K

• Beam Angle: 10º

• Power Requirement: 12V DC, Polarity Protected

• Lifespan: 5,000 Hours

• Warranty: 1 Year

STEP 1

Remove required parts to be able to access battery. Remove
body panels or plastics that will interfere with running the
harness along the frame now.

010-ELV-165

Tech Support: 360-687-4530

[e-mail]

STEP 2

Remove the inline fuse from power harness. Connect the red
lead with the built in fuse holder to the positive terminal on
the battery. Connect the black lead to the negative terminal
on the battery. Run the harness along the frame to the front
of the bike. Make sure to run the harness where it will not get
pinched or rubbed by anything that could damage it.

STEP 3

Run the “Y” harness from the desired light mounting location
to the main power harness. Make sure to run the harness
where it will not get pinched or rubbed through by anything
that could damage it.

STEP 4

Mount three position switch on handlebars in desired loca­tion. If you would like to use the kill switch feature on the
switch you
be the white wire with the female bullet terminal and the
shorter black lead with the ring terminal. The white lead will
connect to your OEM kill switch connection. Next connect the
black lead with the ring terminal to the ground location of the
stock kill switch. Lastly connect the switch to the “Y” harness.

will want to connect these leads now. These will

STEP 5

Mount lights using the included mounting hardware in your
desired location. Once the lights are mounted you can then
plug them into the “Y” harness. Once this is done you can then
install the fuse back into the fuse holder on the power harness.

INSTALLATION TIPS:

Trail Tech’s 70mm LED light kit is provided with a quick
disconnect style connection. The 70mm light has two
brightness modes, 2500 Lumens and 1250 Lumens. Connect
the yellow wire to 12 volt power for 2500 Lumens. Connect
the red wire to 12 volt power for 1250 Lumens.

NOTE: Never supply 12 volt
power to the red and yellow
wire simultaneously.

LED OVERVIEW:

Trail Tech LED lights offer high performance and low power
draw in a small package. Perfect as lightweight helmet lights,
lights for small machines, or auxiliary lights for large
machines. A 30W LED puts out roughly the same amount of
light as a 100W halogen lamp. If your vehicle does not have
DC power, Trail Tech may be able to help convert your
electrical system to DC. Contact your local Trail Tech dealer
for details. (www.trailtech.net)