Trail Tech 7003-AC01 User Manual

AC VOLTAGE REGULATOR

BASIC 12V AC WIRING

OPTION 1: SYSTEMS WITH TWO LIGHTING LEADS:

Trail Tech

Optional On/Off Switch

Lights Wired

in Parallel

ADJUSTABLE AC REGULATOR

010-ELV-106

Tech Support: 360-687-4530

[e-mail]

Stator

Lighting Lead

AC Regulator

Notes on wiring with a Trail Tech stator:

1. This setup does not require a frame ground.

2. The switch is optional. If no switch is used, the lights

turn on and off with the engine. Two switches can be

used to control the lights individually.

OPTION 2: SYSTEMS WITH ONLY ONE LIGHTING LEAD:

Stock Stator

Optional On/Off Switch

Lights Wired

in Parallel

Lighting Lead

Notes on wiring with the Stock Stator:

1. Bolt the negative light leads and the brown regulator

lead to the frame.

2. The switch is optional. If no switch is used, the lights

turn on and off with the engine. Two switches can be

used to control the lights individually.

Lighting Lead

AC Regulator

Frame Ground

Frame Ground

AC VOLTAGE REGULATOR

INFORMATION

ADJUSTABLE AC REGULATOR

010-ELV-106

Tech Support: 360-687-4530

[e-mail]

NOTES:

Improved AC Regulator with Adjustable Output.

•
Limits voltage to 12.0-16.0 volts AC (adjustable.)

•
Conditions circuit to eliminate electrical spikes, protects

•
from lamp blow-outs, and reduces flicker and dimming.
“Dial-a-Brightness” for halogen and quartz lights:

•

At 14.0 VAC setting, the lamps will approach HID

1.

lumens (~70%) but lamp life is short (good for racing.)

2.

At minimum setting, the lamps are not as bright
as HID (~30%), but last over 1,000 hours.

•

Included in Trail Tech plug-and-play high-output AC
electrical systems with model-specific connectors; no
cutting or splicing required. See model-specific wiring
instructions in those kits.

CRIMP KIT:

Use a crimp kit for

professional, water-

tight connections

like those in the

photographs.

P/N: HT230C

Solder and shrink

wrap will also provide

excellent quality

electrical connections.

DIAL-A-BRIGHTNESS

LONG LIFE STANDARD HIGH OUTPUT

~1,000 HOUR LAMP LIFE ~500 HOUR LAMP LIFE ~25 HOUR LAMP LIFE

-1/4

TURNS

12.0 VAC

IMPORTANT:
There is water sealant on the potentiometer. It will not
interfere with a screw-driver adjusting the regulator. Be
sure to re-seal after adjustment to prevent water entering
the regulator and causing damage. Use silicone, nail
polish, or similar to re-seal.

AS

SHIPPED

13.8 VAC

+1/4

TURNS

14+ VAC*

*IMPORTANT:
It is possible to turn the regulator up so far that
the lamp may burn out immediately (voiding lamp
warranty.) Use of a multimeter when calibrating
the regulator is strongly recommended.