TP-Link TL-FC111A-20 User Manual
LED Explanation
PWR
On: Power on
Power o
O:
©2020 TP-Link 7106508844 REV1.0.0
Enlarge Your Ethernet Network
10/100 Mbps WDM Media Converter
Package Contents: Converter, Power Adapter, Installation Guide
Scenario 1: Connect Devices with and without Optical Interfaces
Ethernet Device
with Optical Interfaces
100BASE-X (Fiber) Interface
Media Converter
PWR
10/100M
Link/Act
On: Valid link
Flashing: Transmitting or receiving data
O: Invalid link
Ethernet Device
without Optical Interfaces
Fast Ethernet
LC-SC Fiber Cable
Twisted-Pair Cable
Scenario 2: Connect Devices without Optical Interfaces
Ethernet Device
without Optical Interfaces
Fast Ethernet
Note: Please use one TL-FC111A-20 and one TL-FC111B-20 to work properly.
Media Converter Media Converter
10/100M
PWR
SC-SC Fiber CableTwisted-Pair Cable Twisted-Pair Cable
PWR
10/100M
Fast Ethernet
Specications
General Specifications Environmental and Physical Specifications
Standards
IEEE 802.3, IEEE 802.3i, IEEE802.3u
PWR, Link/ActLED
1 SC ber optic; 1 RJ45 jackConnector
Twisted-Pair
Fiber
Wave Length
100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100 m)
9/125 μm single-mode ber (≤20 km)
TL-FC111A-20: 1550 nm TX, 1310 nm RX
TL-FC111B-20: 1310 nm TX, 1550 nm RX
External Power Adapter: 5 V/0.6 APower
Dimensions 94.5*73*27 mm
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
0˚C to 50˚C (32˚F to 122˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
10% to 90% RH non-condensing
5% to 90% RH non-condensing
To ask questions, find answers, and communicate with TP-Link users or
engineers, please visit https://community.tp-link.com to join TP-Link
Community.
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
If you have any suggestions or needs on the product guides, welcome
to email techwriter@tp-link.com.cn.
Ethernet Device
without optical Interfaces
Safety Information
Keep the device away from water, re, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Adapter shall be installed near the equipment and shall be easily accessible.
Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight.
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due
to improper use of the device. Please use this product with care and operate at your own risk.
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
Loading...