TP-Link TL-ANT2424B User Manual

Electrical Specifications

Frequency Range 2.4GHz ~ 2.5GHz Impedance 50Ω

iBd42 niaG VSWR ≤1.5 Horizontal Beamwidth 14° Vertical Beamwidth 10° F/B Ratio

Polarization Vertical or Horizontal Maximum Input Power 100W Connector N Female Application Outdoor Mount Style Pole Mount / Wall Mount

Mechanical Specifications

Antenna Dimension 600×1000 mm Weight 3.5 +/-0.15 KG Mounting Mast Diameter Ø30~Ø50 mm Rated Wind Velocity 216 Km/h

＞30dB

User Guide

TL-ANT2424B

24dBi 2.4GHz Grid Parabolic Antenna

Rev:1.0.0 7106500760

Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2009 TP-LINK TECHNOLOGIES CO., LTD. All rights reserved.

http://www.tp-link.com

Installation:

1. Assembly the two pieces of reflector symmetrically.

2. Mount the feed horn on the reflector according to the Mounting diagram. Make sure the feed dipoles parallel with most bars of the grid reflector. When the feed dipoles and most grid bars are vertical to the ground, the antenna is vertical polarized. When the feed dipole and most grid bars are horizontal to the ground, the antenna is horizontal polarized.

3. Mount the “L” type bracket at the back of the reflector, then mount the antenna on the mast supplied by customer according to the Mounting diagram.

4. Test the antenna with equipment to make sure the antenna receive the best signal by turning the azimuth and pitching angle, then lock all the screws and seal the connector between antenna and cable.