Tp-link TF-5239 User Manual

specification, such as 10Mbps 10Base-T or 100Mbps 100BaseTX. Then recheck the LED.

Product's LED

LED F indicates the 100Mbps Link, meaning whether the product connect to the network at 100Mbps speed. LED L indicates the 100Mbps Link, meaning whether the product connects to the network at 100Mbps speed. If both of these two LEDs are light, the STP/UTP port doesn't link to the network. If only LED F is light, it means data transmission at 100Mbps or normal network link. If only LED L is light, it means data transmission at 10Mbps or normal network link.

Appendix B Technical Specification

Topology Star RJ45

Connector Supported Standard IEEE802.3 10Base-T, IEEE802.3u 100Base-TX, PC Card Type II Transmission Rate 10Mbps or 20Mbps, 100Mbps or 200Mbps Software ODI Driver for NetWare 3.x, 4.x, Microsoft Windows 9x, Windows NT, Windows 2000, Windows ME, etc. Operating Temperature

0 to 40 Store Temperature -40 to 70 Humidity 10% to 90% (Non-condensing) Dimension 115mm 54mm 14mm

User's Guide

10/100M Fast Ethernet PC Card

Rev:1.0

71030295

Chapter 1 Introduction

Hardware Overview

The product is a 10/100Mbps Fast Ethernet 32-bit CardBus adapter for notebooks. With the built-in connector, a RJ-45 LAN cable can be directly plugged into a notebook computer. The product complies with IEEE 802.3 10Base-T Ethernet and IEEE

802.3u 100Base-TX Fast Ethernet standard. The product completely supports IEEE802.3x full-duplex flow control, supports both 10Mbps and 100Mbps network speed and supports both Half-duplex and Full-duplex no matter the speed. The product uses Auto-Negotiation technology to detect the network speed.

Features & Benefits

! Comply with IEEE802.3 10BASE-T and IEEE802.3u

100BASE-TX Ethernet Standard

! PCMCIA Type II 32-bit Cardbus PC card

! One RJ-45 connector for 10Mbps or 100Mbps network Speed

! Low energy consumption

! Provide diagnostic software and two LEDs to indicate

network situation

! Plug-and-Play

! Support ACPI, PCI power management

! Supports Full Duplex Flow Control (IEEE 802.3x)

! Full duplex design to double the performance to

20Mbps/200Mbps

! Supports Auto-Negotiation function

! Support ODI Driver for NetWare 3.x, 4.x, Microsoft Windows

9x, Windows NT, Windows 2000, Windows ME, etc.

Chapter 2 Installation

Card Installation

To insert the product into your PC, follow the steps list below.

1. Insert the product into a PC card slot of the notebook.

2. If you didn't install the driver before you insert the card, the system will remind you to install the driver when the system find the hardware. If there is a driver which has been configed correctly, you can access the network through this card.

3. Put one end of the STP/UTP cable to the RJ-45 port of the product, put another end to the RJ-45 port of the network.

Driver Installation

Use the drivers supplied by the diskette included in the product. For detail description, please refer to the folder help in the diskette provided by the product.

Appendix A Troubleshooting

If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub complies with the adapter

1 2