TP-Link LS105G, LS108G, LS1005G, LS1008G, TL-SF1005LP Wall Mounting Guide

Wall Mounting Guide

Wall Mountable Switches

1.1 Wall Mounting Preparation

Before mounting the switch, you need to prepare the tools below:

Ǵ A screw driver.

Ǵ Two screws which complies to the corresponding standard. For details, see Wall

Mounting Specification.

1.2 Wall Mounting Procedure

On the bottom of the panel, there are two mounting holes. You need to drive two screws
into the wall, then mount the switch on the wall. Note that the switch should be mounted
on the wall upright rather than sideways.

1) Determine the location on the wall where you want to mount the switch.

2) Mark the wall where the two mounting holes are. The distance between the two marks
must be the same as that between the two mounting holes of the switch. For the wall­mounting-holes distance, see Wall Mounting Specification.

3) Drive the screws into the wall at the marks using the screw driver. For the Screw­Head-to-Wall Minimum Distance, see Wall Mounting Specification.

4) Mount the switch on the wall.

1.3 Wall Mounting Specification

Model

Screw Standard of

ANSI B1.1

LS105G 4#, (5#), 6# 7mm 1.5mm 76mm

LS108G 4#, (5#), 6# 7mm 1.5mm 65mm

LS1005G 4#, (5#), 6# 7mm 1.5mm 38mm

LS1008G 4#, (5#), 6# 7mm 1.5mm 48mm

TL-SF1005LP 4#, (5#), 6#, 8# 8.5mm 1.5mm 39mm

TL-SF1005P 4#, (5#), 6#, 8# 8.5mm 1.5mm 39mm

TL-SF1006P 4#, (5#), 6#, 8# 8.5mm 1.5mm 94mm

TL-SF1008LP 4#, (5#), 6#, 8# 8.5mm 1.5mm 105mm

TL-SF1008P 4#, (5#), 6#, 8# 8.5mm 1.5mm 105mm

Minimum Length

of Screw

Screw-Head-to-Wall

Minimum Distance

Wall-Mounting-Holes

Distance

TL-SF1009P 4#, (5#), 6#, 8# 8.5mm 1.5mm 105mm

TL-SF1016D 4#, (5#), 6# 8.5mm 1.5mm 157.2mm

TL-SG1005LP 4#, (5#), 6#, 8# 8.5mm 1.5mm 39mm

TL-SG1005P

TL-SG1008D

4#, (5#), 6#, 8# 8.5mm 1.5mm 39mm

4# 8mm 2mm 100mm