INTRODUCTION
Congratulations on your choice of the RS3200 PLUS add-on security system to protect your vehicle!
To get the most from the system, we strongly recommend that you read this Owner’s Guide completely to learn all of its features and functions.
The RS3200 P
LUS provides security through point-of-entry monitoring, glass breakage detection and
ignition switch monitoring. While A
RMED, the system will be TRIGGERED and sound an ALARM when a
door, trunk or hatch is forcibly unlocked or opened*, or when a window is tapped on or broken.
During the A
LARM, the vehicle’s horn sounds and the headlights, tail lights and front marker or turn
signal lights flash. Also, the vehicle’s starter is disabled, preventing engine start. In addition to the
comprehensive protection, the RS3200 P
LUS works in conjunction with your vehicle’s remote key-
less entry system, enabling you to A
RM and DISARM the security system at the same time the doors
are remotely locked and unlocked. In vehicles equipped with a buzzer, it will chirp when the system
is R
EMOTE ARMED and DISARMED.
An important note about your system
Throughout this guide, there are references to the S
TATUS MONITOR for this system. Illustrated
below, this panel holds the LED indicator (for the system’s operating status) and the G
LASS
BREAKAGE SENSOR’S microphone. In vehicles equipped with an engine immobilizer system, there is
a LED already installed, so the RS3200 P
LUS utilizes the vehicle’s engine immobilizer system LED
instead and a microphone mounted in a separate location. If your vehicle falls into this category,
remember to look at that LED when the information refers to the S
TATUS MONITOR. If you do not
know where the LED is located, refer to your vehicle’s owner’s guide for specific information.
* When the system is P
ASSIVELY (AUTOMATICALLY) ARMED, there is an ENTRY DELAY that will elapse
when a door is opened before an A
LARM is TRIGGERED.
YOUR ENGINE IMMOBILIZER
SYSTEM LED MAY LOOK
DIFFERENT THAN THE ONE
ILLUSTRATED HERE
Page 2 TOYOTA RS3200 PLUS Security system
LIGHTS
FOR 30
SECONDS
(PRE-
ARMING)
THEN
STARTS
FLASHING
(SYSTEM
IS
ARMED)
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond entry point monitoring–it
“listens” for the noise made by tapping on, or breaking of glass. Using a microphone designed
specifically for this task, the G
LASS BREAKAGE SENSOR is capable of ignoring other noises, which
helps to prevent “false alarms” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to adjust the sensitivity level
of the G
LASS BREAKAGE SENSOR. You may observe how it works following the procedure listed
below.
1. A
RM the system.
Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not A
hatch is open.)
2. Wait until the S
The LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
3. With the tip of a key, tap the center of the driver’s door window.
Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially
A W
ARN AWAY ALARM should be TRIGGERED. If the ALARM is not
T
RIGGERED, make sure you performed the procedure correctly
and try again. If you find that the system did not perform as
expected, contact your Toyota dealer for more information.
4. DISARM the system to stop the WARN AWAY ALARM.
Press the unlock button on the remote control or use the key
to D
ISARM the system.