Toyota 95-8211 User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-8211

APPLICATIONS

Toyota Avalon

2000-2004

95-8211

KIT FEATURES

• Double DIN Radio Provision

• Stacked ISO Mount Units Provision

KIT COMPONENTS

A) Double DIN Trim Plate

A

TOOLS REQUIRED:

Small Flat Blade Screwdriver • Panel Removal Tool

• Phillips Screwdriver • Socket Set

1-800-221-0932

© COPYRIGHT 2004 METRA ELECTRONICS CORPORA

www.metr

aonline.com

TION

95-8211

TABLE OF CONTENTS

Dash Disassembly

- Toyota Avalon 2000-2004 (column shift models) . . . . . . . . . . . . . . . . . . . . . 1

- Toyota Avalon 2000-2004 (console shift models) . . . . . . . . . . . . . . . . . . . . . 2

Assembly

Kit

- Double DIN Radio Provision .......................................3

- Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Final

*Note:
Refer also to the instructions included with the aftermarket radio.

5

95-8211 DASH DISASSEMBLY

R

O

FF

A

/C

TOYOTA AVALON 2000-2004

(column shift models)

*Note: Refer also to the instructions included with the aftermarket radio.

A

Disconnect the negative battery-

1

terminal to prevent an accidental
short circuit.

Unsnap the trim below the cli-

2

mate control to reveal (2) 10 MM
bolts and remove.

Carefully pull air vents above

3

(Figure A)

radio towards rear of car to
unsnap. NOTE: There are (3)
snaps, (2) are at the bottom sides
and (1) is at the top middle of the
vent assembly.

Remove (2) 10 MM bolts from

4

(Figure B)

B

above radio/climate control
assembly. Unplug and remove
assembly together.

Remove (6) Phillips screws (4

5

(Figure C)

from radio and 2 from climate
control) from each side bracket to
separate radio and climate con­trol. (Save climate controls and
brackets to reuse during kit
assembly).

(Figure D)

Continue to kit assembly.

D

C

1