Toner Cable LLM-1770 User Manual

//0 /RXGQHVV/RJJHUV

969 Horsham Road lHorsham, Pennsylvania 19044 USA l Phone: [phone] Fax: [phone] [e-mail]

speciFications

Specifications are subject to change without notice.

Features

Loudness measurement to ITU-R BS.1770•
True peak measurement to ITU-R BS.1770 with five times oversampling•
Configurations for EBU R-128 and ATSC A/85•
Internal data storage for five days of loudness and alarms•
Export values to a PC via Ethernet or USB•
Front-panel display of critical values•
Simultaneous monitoring of surround and stereo•
Alarms for levels, loudness and timecode•
Four AES inputs•
Optional SDI input•
Headphone output•
LTC input for time stamps•
Remote control and monitoring via web browser•

Digital Audio Input

Audio Formats . . . . . . . . . . . . . . . AES, embedded audio (optional)

AES Input Connector Type . . . . . . . 4 BNC, female

AES Input Impedance . . . . . . . . . . 75 ohms nominal

AES Input Return Loss . . . . . . . . . ≥25 dB, 0.1 to 6 MHz (unbalanced)

AES Input Level . . . . . . . . . . . . . . 0.2 to 2 V

AES Input Sample Rate . . . . . . . . . 32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz

. . . . . . . . . . . . . . . . . . . . . . . . . . Note: audio inputs are sample rate converted to

48 kHz

Meter Accuracy Over Frequency . . ±0.1 dB from 20 Hz to 19 kHz with 0 to -40

dBFS sine wave input, except for within 7 Hz of
some submultiples of the 240 kHz oversampling
frequency

3G-SDI Input

Input Type . . . . . . . . . . . . . . . . . . 1 active looping input

Input Connector Type . . . . . . . . . . BNC, female

Input Impedance . . . . . . . . . . . . . 75 ohms nominal

Signal Source Amplitude . . . . . . . . 800 mV nominal

Signal Source DC Offset . . . . . . . . ±0.5 V

Input Return Loss . . . . . . . . . . . . . ≤-10 dB, 1.485 to 2.97 GHz

Cable EQ . . . . . . . . . . . . . . . . . . . ≥80 m, Belden 1694A

HD-SDI Input

Input Type . . . . . . . . . . . . . . . . . . 1 active looping input

Input Connector Type . . . . . . . . . . BNC, female

Input Impedance . . . . . . . . . . . . . 75 ohms nominal

Signal Source Amplitude . . . . . . . . 800 mV nominal

Signal Source DC Offset . . . . . . . . ±0.5 V

Input Return Loss . . . . . . . . . . . . . ≤-15 dB, 270 MHz to 1.485 GHz

Cable EQ . . . . . . . . . . . . . . . . . . . ≥100 m, Belden 8281

The Videotek® LLM-1770 loudness logger and monitor is a compact audio moni­toring tool that makes it easy to confirm compliance with the latest loudness
requirements. Loudness and true peak measurements are made to the ITU-R
BS.1770 standard with five times oversampling.

Settings are included that match the EBU R-128 and ATSC A/85 recommenda­tions. Internal memory stores five days of loudness and alarm data. Logs can be
exported via Ethernet or USB. Remote control and monitoring can be performed
from any web browser.

The LLM-1770 comes with four AES inputs and has an option for SDI embedded
from SD, HD or 3 Gb/s sources. There is a headphone jack for local confidence
monitoring.

SD-SDI Input

Input Type . . . . . . . . . . . . . . . . . . 1 active looping input

Input Connector Type . . . . . . . . . . BNC, female

Input Impedance . . . . . . . . . . . . . 75 ohms nominal

Signal Source Amplitude . . . . . . . . 800 mV nominal

Signal Source DC Offset . . . . . . . . ±0.5 V

Input Return Loss . . . . . . . . . . . . . ≤-25 dB, 5 to 270 MHz

Cable EQ . . . . . . . . . . . . . . . . . . . ≥300 m, Belden 8281

3G/HD/SD-SDI Output

Output Impedance . . . . . . . . . . . . 75 ohms

Output Return Loss . . . . . . . . . . . ≤-15 dB, 5 MHz to 1.485 GHz

Output Return Loss . . . . . . . . . . . ≤-10 dB, 1.485 to 3 GHz

Output Signal Level . . . . . . . . . . . 800 mV ±10%

Output DC Offset . . . . . . . . . . . . . 0 V ±0.5 V

Analog Monitoring Output (Headphone)

Number/Connector . . . . . . . . . . . . 1 stereo output, 1/8 in. (3.5 mm) headphone jack

Load Impedance . . . . . . . . . . . . . 16 ohms, nominal

Maximum Output Level. . . . . . . . . 44 mW RMS

Total Harmonic Distortion and . . . . ≤-65 dB

Noise (THD+N)

Control

GPI . . . . . . . . . . . . . . . . . . . . . . . 4 total user-configured

GPO . . . . . . . . . . . . . . . . . . . . . . 1 alarm, user-configured

Connector . . . . . . . . . . . . . . . . . . 15-pin HD (high-density) D-sub, female

Input Impedance . . . . . . . . . . . . . 10 k ohms returned to +3.3 VDC

Alarm Output . . . . . . . . . . . . . . . . Relay closure

Maximum Relay Current . . . . . . . . 100 mA @ 50 VDC

Peripheral Interface . . . . . . . . . . . USB 2.0 supporting storage devices, and keyboard

Connector . . . . . . . . . . . . . . . . . . USB 2.0, type A, female

Specifications

//0/RXGQHVV/RJJHUV

Timecode

Input . . . . . . . . . . . . . . . . . . . . . . LTC via back-panel connector

Communication Interfaces

Ethernet . . . . . . . . . . . . . . . . . . . 1 Ethernet port RJ-45 10/100Base-T connector

USB . . . . . . . . . . . . . . . . . . . . . . 1 USB 2.0 host port

LTC/GPIO . . . . . . . . . . . . . . . . . . . 1 LTC/GPIO connector 15-pin female D-sub

Ethernet

Standard . . . . . . . . . . . . . . . . . . . 10/100Base-T conforms to IEEE802.3

Connector . . . . . . . . . . . . . . . . . . RJ-45

Power Requirements

Power Connector . . . . . . . . . . . . . 15 VDC, nominal; 11 VDC, minimum;

17 VDC, maximum

Power Consumption . . . . . . . . . . . 25 W, nominal

Over-Voltage Protection . . . . . . . . ±50 VDC, nominal

iMaGes/DiaGraMs

Back Panel

LTC/GPI

ETHERNET

AES IN

Mechanical

Dimensions (H x W x D) . . . . . . . . 5.22 x 8.46 x 5.8 in. (13.26 x 21.49 x 14. 73 cm)

Weight . . . . . . . . . . . . . . . . . . . . 5 lbs (2.27 kg)

Environmental

Operating Temperature . . . . . . . . . 32° to 122° F (0° to 50° C)

Storage Temperature . . . . . . . . . . -22° to 149° F (-30° to 65° C)

Humidity (non condensing) . . . . . . Operating: 20% to 80%

Non-operating: 5% to 90%

Transportation . . . . . . . . . . . . . . . 24 in. (9.5 cm) impact drop survivable in original

factory packaging

Altitude (Operating) . . . . . . . . . . . 6562 ft (2000 m)

Pollution Degree . . . . . . . . . . . . . 2

Standard Accewwssories . . Installation and operation handbook on CD

Breakout connector for LTC/GPI

1 power cord

1 power supply assembly

SDI

OUTIN4321

POWER 11 - 17 VDC

orDerinG inForMation

OPTIONS

LLM-1770 . . . . . . . . . . . . . . . . . Loudness logger and monitor with 4 AES inputs,

headphone output

LLM-OPT-SDI . . . . . . . . . . . . . . . SD-SDI input option for the LLM-1770; adds

embedded audio from SD, HD or 3 Gb/s SDI
sources

LLM-OPT-SDI-F . . . . . . . . . . . . . SD-SDI input option for the LLM-1770; adds

embedded audio from SD, HD or 3 Gb/s SDI
sources, field upgrade

DRT-4 . . . . . . . . . . . . . . . . . . . . Dual rackmount adapter; mount 1 or 2 LLM-

1770, CMN-41, CMN-MV in a 19 in. (48.2 cm)

equipment rack, 1RU high

BLK-4 . . . . . . . . . . . . . . . . . . . . Blank panel for unused side of a DRT-4

PTC-4 . . . . . . . . . . . . . . . . . . . . Desktop case with tilt bail

Specifications Subject To Change Without Notice Rev 11-12 ©Toner Cable Equipment, Inc.

969 Horsham Road lHorsham, Pennsylvania 19044 USA l Phone: [phone] Fax: [phone] [e-mail]