Tomy TFY7292P, TFY7292C Users Manual

MODELS: Y7291 AND Y7292
• To prevent electric shock or strangling by the cord, do not place the monitor in, or attach it to, a crib or playpen.
• Never place these units within a child’s reach.
• The product is designed to assist in the monitoring of children, not as prevention for injury to or loss of a child.
• This product is not a substitute for proper adult supervision. All children should be supervised at all times by responsible adults.
WARNING:
True Choice™ Premium Digital Monitor
(P300 and P400)
Questions? Comments?
Contact Consumer Care
www.learningcurve.com
800-704-8697
!
Note: P300 comes with one Child Unit, one
Parent Unit, one rechargeable battery pack and two AC adapters.
P400 comes with one Child Unit, two Parent Units, two rechargeable battery packs and three AC adapters.
Except for setting up (and using) the second Parent Unit, instructions for both models are the same.
QUICK START INSTRUCTIONS
You’ll find detailed instructions inside. Please read the safety instructions on page 2.
Set up the Parent Unit(s)
• For portable use: Install the battery pack. Battery compartment is located on the back of the unit. Loosen screw to release it, and lift cover off. (for easier access, press on top of belt clip to hold it out of the way.) Insert plug on battery pack into connector inside compartment, then fit battery into place with battery info side facing up.
IMPORTANT: Charge battery for 8 hours before first use
• For plug-in use: Connect one of the AC adapters provided
Set up the Child Unit
• Place the Child Unit near your child (within 6 feet, but well beyond child’s reach).
• Connect the remaining AC adapter to the unit and plug into wall outlet
To Use:
1 Press and release to turn the Child Unit on and wait for connection indicator to blink. 2 Press and release the button on the side of the Parent Unit to turn it on. 3 Connection indicators on all units should glow blue indicating connection. 4 Press [+] or [-] to adjust volume of Parent Unit(s). 5 Keep the Parent Unit within hearing distance.
Before returning this product to the store for any reason, please contact our
Parent Service Center at 1-800-704-8697 or www.learningcurve.com
Often, we can provide helpful tips and instructions to resolve your problem
quickly over the phone or by e-mail.
P300 Parent Unit
Child Unit
P400 Parent Units
Safety Instructions
This symbol is intended to warn the user of potential safety hazards.
This symbol is intended to alert the user to a potential risk of electric shock and other electrical safety issues.
WARNING:
To reduce the risk of fire or electrical shock, do not open this product or expose this product to:
Water And Moisture: This product should not be used near water, for example, near a bathtub or sink, in a wet basement or near a swimming pool.
Heat: This product should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances that produce heat.
IMPORTANT:
• The user should not attempt to service this product. Read all safety and operating instructions before operating this product.
• Retain these instructions for future reference.
• Observe all warnings.
• Follow all operating instructions.
• Do not tamper with the plug under any circumstances.
• Power Source - This product should be connected only to the power supply provided.
• Cleaning - Before cleaning, be sure to unplug. Clean only as recommended in these instructions.
• Object And Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through the openings.
• Damage Requiring Service - This product should be serviced by qualified service personnel when: a. The power supply cord or plug has been damaged b. Objects have fallen or liquid has been spilled into it c. The product has been exposed to rain d. The product does not appear to operate normally or exhibits a marked change in its performance e. The product has been dropped or the enclosure damaged.
Refer All Servicing To A Qualified First Years® Technician
(Call 1-800-704-8697 if you believe your unit needs service).
Wall Mounting - The Child Unit should be mounted to a wall only as recommended in these instructions.
WARNING:
Do not mount the Child Unit in a location where the unit and the adaptor cord is within the child’s reach.
IMPORTANT: Changes or modifications to this unit not expressly approved by Learning Curve Brands Inc. could void the user’s authority to operate equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
These devices comply with FCC and Industry Canada RF radiation exposure limits set forth for general population. They must not be operated when co-located with any other antenna or transmitter.
2
3
Contents and Features
Child Unit, Parent Unit(s) and AC Adapter
Power button
Power button Power indicator
Talk button(s)
Sound lights
Connection indicator
AC adapter
Sound lights
Connection indicator
Power indicator
Connection indicator
Battery pack
Volume control
Headphone jack
P300 Talk Button
AC jack
Parent Unit(s)
Removable belt clip/stand
P400 Talk Buttons
DC
6V
Nightlight
AC jack
Cord channel
Child Unit
Reset hole
Talk-back Volume setting
Wall mount slot
R
E
S
E
T
4
To Set Up - Child Unit
WARNING:
Do not place Child Unit in crib or attach to crib or playpen.
WARNING:
Do not mount the Child Unit in a location where the unit or the adaptor cord is within the child’s reach.
1. Position the Child Unit within 4 to 6 feet of your child. NEVER position the unit within a child’s reach.
2. Insert the connector on the AC adapter into the jack on the back of the unit, then plug the adapter into an electrical outlet.
1. Press the adapter cord into the grooved channel on the back of the unit, making certain to slide it under the two holding clips.
2. Securely fasten a #8 “pan” head screw to the wall, leaving the screw head protruding by at least 1/4 inch. For best results use a 3/4-inch long screw; mount in a solid wood panel, or use a screw anchor.
3. Fit the round opening on the
wall mount slot over the screw head, then slide the unit down until it is seated firmly.
4. To test that unit is securely
mounted: press on its top and side edges.
Loosen the screw to release the battery compartment cover, then lift it off. Insert three AAA batteries, positioning them so the + and – on the batteries are aligned with the corresponding marks in the battery compartment. Replace the cover and secure it by tightening the screw.
IMPORTANT: Use of batteries to power the Child’s unit is intended only for temporary use during a power outage or when a plug-in electrical outlet is unavailable. Check low battery indicator often, and replace batteries as necessary.
For wall mounting (optional)
For temporary/battery-powered operation
+
+
+
-
-
-
R
E
S
E
T
R
E
S
E
T
#8 “pan” head screw
Loading...
+ 7 hidden pages