IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs. Use oven
mitts or potholders.
3. To protect against electrical shock, do not immerse cord or
plugs in water or other liquid.
4. Close supervision is necessary when any appliance is used
near children.
5. Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts, and before
cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions, or has been damaged in
any manner. Contact Consumer Service for examination,
repair or adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. Extreme caution must be used when moving an appliance
containing hot oil or other hot liquids.
12. Always attach plug to appliance first, then plug cord in the
wall outlet. To disconnect, turn any control to “OFF”, then
remove plug from wall outlet.
13. Do not use appliance for other than intended use.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
1
ADDITIONAL
IMPORTANT SAFEGUARDS
CAUTION HOT SURFACES: This appliance generates heat and
escaping steam during use. Proper precautions must be taken to
prevent the risk of burns, fires, or other injury to persons or damage to property.
CAUTION: This appliance is hot during operation and retains
heat for some time after turning off. Always use oven mitts when
handling hot materials and allow metal parts to cool before cleaning. Do not place anything on top of the appliance while it is operating or while it is hot.
1. All users of this appliance must read and understand this
Owner’s Manual before operating or cleaning this appliance.
2. The cord to this appliance should be plugged into a 120V AC
electrical outlet only.
3. If this appliance begins to malfunction during use, immediately unplug the cord. Do not use or attempt to repair the malfunctioning appliance.
4. Do not leave this appliance unattended during use.
2
GROUNDED 3-CONDUCTOR PLUG
This appliance is equipped with a grounded-type 3-wire cord (3prong plug). This plug will only fit into an electrical outlet made for
a 3-prong plug. This is a safety feature. If the plug should fail to fit
the outlet, contact an electrician to replace the obsolete outlet. Do
not attempt to defeat this safety feature.
SHORT CORD INSTRUCTIONS
A short power-supply cord is provided to reduce the risk resulting
from becoming entangled in or tripping over a longer cord.
Do not use an extension cord with this product.
PLASTICIZER WARNING
CAUTION: To prevent Plasticizers from migrating from the finish
of the countertop or tabletop or other furniture, place NON-PLASTIC coasters or placemats between the appliance and the finish
of the countertop or tabletop.
Failure to do so may cause the finish to darken, permanent blemishes may occur, or stains can appear.
ELECTRIC POWER
If the electrical circuit is overloaded with other appliances, your
appliance may not operate properly. It should be operated on a
separate electrical circuit from other appliances.
3
TEMPERATURE CONTROL PROBE
The Temperature Control Probe is the nerve center and brain of
the Electric Skillet. Treat it carefully. Dropping or banging it could
change its calibration and make the temperature settings inaccurate.
Select the temperature as called for in the recipe. Allow Skillet to
cool before removing the Temperature Control Probe.
To clean the Temperature Control Probe, simply wipe down with a
soft, damp cloth. Make sure you dry it thoroughly before using
again.
NOTE: The Temperature Control Probe is not immersible.
CAUTION: Use only the Temperature Control Probe (P/N
22739) supplied with this product. Using any other type of
Temperature Control Probe may cause fire, electric shock, or
injury.
BEFORE FIRST USE
Read all instructions carefully. Remove the Temperature Control
Probe from the Electric Skillet and set it aside.
Wash the Electric Skillet and Glass Lid in hot, sudsy water. Rinse
and dry thoroughly.
4