When using electrical appliances, basic safety precautions
should always be followed including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles.
3. To protect against electrical shock do not immerse cord,
plugs, or appliance in water or other liquid.
4. Close supervision is necessary when any appliance is used
by or near children.
5. Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts.
6. Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions or has been damaged in
any manner. Contact Consumer Service for examination,
repair or adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a
heated oven.
11. Extreme caution must be used when moving an appliance
containing hot oil or other hot liquids.
12. To disconnect, turn any control to OFF, then remove plug
from wall outlet.
13. Do not use appliance for other than intended use.
SAVE THESE INSTRUCTIONS
For Household Use Only
1
ADDITIONAL IMPORTANT SAFEGUARDS
CAUTION HOT SURFACES: This appliance generates heat
and escaping steam during use. Proper precautions must
be taken to prevent the risk of burns, fires, or other injury
to persons or damage to property.
1. A person who has not read and understood all operating and
safety instructions is not qualified to operate this appliance.
All users of this appliance must read and understand this
Owner’s Manual before operating or cleaning this appliance.
2. If this appliance falls or accidentally becomes immersed in
water, unplug it from the wall outlet immediately. Do not reach
into the water!
3. When using this appliance, provide adequate air space above
and on all sides for air circulation. Do not operate this
appliance while it is touching or near curtains, wall coverings,
clothing, dishtowels or other flammable materials.
4. To reduce the risk of fire, do not leave this appliance
unattended during use.
5. If this appliance begins to malfunction during use,
immediately unplug the cord. Do not use or attempt to repair
a malfunctioning appliance!
6. The cord to this appliance should only be plugged into a
120V AC electrical wall outlet.
7. Do not use this appliance in an unstable position.
8. Do not use the Food Steamer if the Drip Tray or Steamer
Base, or if any Steamer Bowl is cracked or damaged.
9. Make sure the Food Steamer is unplugged and the steaming
water has cooled before cleaning.
2
10. Never plug the Food Steamer into the wall outlet until you
snap the rings into position around the heating elements.
Next, fill the Steamer Base with water and then place the
Drip Tray inside the Steamer Base.
11. Avoid electric shock by unplugging the Steamer
before washing.
12. To avoid steam burns, position the Lids’ Steam Vents
towards the back of the unit during cooking.
WARNING: Steam is hot and can cause burns. Keep hands
and face away from Steam Vents in the Lids during cook-
ing. Use protective oven mitts to remove Steamer Bowls
from the Base and to lift the Lids. When removing the Lids
after steaming, always tilt Lids away from your face to
avoid burns caused from steam.
13. The Steamer Base and components are not for use in ovens
(microwave, convection, or conventional) or on a stove-top.
CAUTION: While steaming, make sure the Food Steamer is
placed in a secure area that will not be bumped, pushed or
disturbed in any manner.
14. Before pressing the ON/OFF Button, make sure that the
Steamer Bowls are securely sitting in the Drip Tray – and the
Drip Tray is securely sitting in the Steamer Base. Make sure
that the food is evenly distributed within each Steamer Bowl
and each Lid is properly affixed before steaming.
3
Polarized Plug
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended
to fit into a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug in
any way.
Short Cord Instructions
A short power-supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord.
Do not use an extension cord with this product.
Plasticizer Warning
CAUTION: To prevent Plasticizers from migrating from the finish
of the countertop or tabletop or other furniture, place
NON-PLASTIC coasters or placemats between the appliance
and the finish of the countertop or tabletop. Failure to do so may
cause the finish to darken, permanent blemishes may occur or
stains can appear.
Electric Power
If the electrical circuit is overloaded with other appliances, your
appliance may not operate properly. It should be operated on a
separate electrical circuit from other appliances.
4
Getting To Know Your Richard Simmons
EST7/EST7QVC/EST7 INF Electronic Steamer
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
5
1. Lid for Center Steamer Bowl
(P/N 22787)
2. Lid for Side Steamer Bowl x 2
(P/N 22788R and P/N 22788L)
3. Side Steamer Bowl x 2
(P/N 22789)
4. Center Steamer Bowl
(P/N 22790)
5. Drip Tray (P/N 22791)
6. Steam Ring x 3 (P/N 22792)
7. Water Level Sensor –
DO NOT REMOVE
8. WATER REFILL Opening
9. Water Window
10. Control Panel
11. Steamer Base with
3 Heating Elements
12. Flavor Tray
13. Cooking Bowl (P/N 22793)
14. Steam Vents (not shown)
Figure 1: Control Panel
BEFORE FIRST USE
CAUTION: Do not immerse cord, plug, or Steamer Base
with Heating Elements in water or other liquids.
IMPORTANT: Never place Lids, Cooking Bowl, Steamer
Bowls or Drip Tray on a hot stove or in a microwave.
1. Unpack the Food Steamer and accessories, removing all
packaging materials.
2. Wash Steamer Bowls, Lids, Cooking Bowl, Drip Tray and
Steam Rings in mild dishwashing detergent. Rinse and
dry thoroughly.
NOTE: Removable parts are dishwasher-safe (top rack only).
6
OPERATING INSTRUCTIONS
Setting Up
1. Make sure that the Steamer is unplugged. Place the Steamer
Base on a flat sturdy surface with adequate clearance.
2. Place the Steam Rings around the Heating Elements so that
the end with the small hole faces down.
3. Using a spouted vessel, fill the Steamer Base with water until
it reaches the Maximum Fill Line located on the inside of the
Steamer Base (approximately 10 cups).
4. Place the Drip Tray onto the Steamer Base, making sure that
it is positioned correctly.
5. Fill the Steamer Bowls with desired food (refer to the HINTS &
TIPS, STEAMING CHARTS and RECIPES sections of this
Owner’s Manual for meal suggestions and guidelines). When
placing food into the Steamer Bowls, make certain not to
block all of its steam holes; there must be adequate air
circulation around the food to ensure even steaming. Food
should be cut into uniform-sized pieces and distributed
evenly within each Steamer Bowl. After filling, place the
appropriate lid on each Steamer Bowl.
WARNING: Do not overfill Steamer Bowls as this will
prevent proper steaming. Only fill the Steamer Bowls
approximately half full with food.
NOTE: Make sure that all 3 Steamer Bowls are securely
positioned on the Steamer Base, even if they are not being used
for steaming; and that each Lid is securely positioned with the
Steam Vents facing toward the back of the unit.
Using the Cooking Bowl:
Use the Cooking Bowl to prepare white, brown or wild rice or to
steam other foods. Simply add the desired ingredients into the
Cooking Bowl, place the Cooking Bowl inside the Large/Center
Steamer Bowl, then cover with the Lid.
7
Refer to the HINTS & TIPS, STEAMING CHARTS and RECIPES
sections of this Owner’s Manual for more detailed instructions on
cooking rice and other foods in the Cooking Bowl.
6. To enhance flavor: Add
1
⁄4 teaspoon of fresh/dried herbs or
spices plus 1 teaspoon of water into the Flavor Tray under
each of the desired Steamer Bowls (each Steamer Bowl has
its own Flavor Tray). See “Herbs, Spices and Seasonings” in
the RECIPES section of this Owner’s Manual for more flavor
enhancing ingredients.
7. Position the Steamer Bowls onto the Drip Tray so that the
Steam Vents on each of the Lids are facing toward the back
of the unit.
Steaming
CAUTION: Make sure that all 3 Steamer Bowls are
securely positioned on the Steamer Base, even if they are
not being used for steaming; and that each Lid is securely
positioned with the Steam Vents facing toward the
back of the unit.
CAUTION: Make sure the Steamer is placed in a
secure area that will not be bumped or disturbed in any
manner, or where steam could damage
upper cabinets, curtains, etc.
1. Plug the power cord into a 120V AC electrical outlet. The
Food Steamer will enter into Standby Mode; the Display will
show like in Figure 2.
Figure 2
8
2. To set the cooking time, press the BOWL SELECT Button until
the desired Steamer Bowl is flashing in the Display (Figure 3).
Figure 3
3. Enter the cooking time using the + and – Buttons, then press
the BOWL SELECT Button to select the next Steamer Bowl.
The BOWL will stop flashing in the Display to indicate that it
is set.
NOTE: Each cooking time may be set for up to 99 minutes.
Hold down the + or – Button to advance through the cooking
times faster.
4. Repeat Steps 2 & 3 until each Steamer Bowl is set for the
appropriate cooking time.
CAUTION: Make sure that all 3 Steamer Bowls are
securely positioned on the Steamer Base, even if they are
not being used for steaming; and that each Lid is securely
positioned with the Steam Vents facing toward the back of
the unit. Simply do not enter a cooking time for any
Steamer Bowl that is not being used.
5. Once all of the cooking times have been entered, press the
SET Button to confirm. All BOWL icons will stop flashing in
the Display. The Steamer will not start cooking until the
ON/OFF Button is pressed.
NOTE: To adjust any of the cooking times, press the BOWL
SELECT Button until the desired Steamer Bowl is selected, and
then use the + and – Buttons to revise the cooking time. Press
the SET Button again to confirm.
9
6. Press the ON/OFF Button to begin cooking. The red Power
Light will illuminate, indicating that the Food Steamer is in
use; and the Steamer Bowl with the longest cooking time will
start counting down in the Display. Each Steamer Bowl will
start counting down at the appropriate time, so that all of the
Steamer Bowls are finished cooking at the same time.
NOTE: If at any time during steaming the water level falls below
the Minimum Water Fill Line marked next to the Water Window,
the Display will flash and an audible beep will sound. The
Heating Elements will stay ON and the Timer will continue to
countdown. When the Display flashes and the audible beep
sounds faster, the Heating Elements will turn off and the Timer
will stop counting down.
To Refill the Steamer Base: Use a spouted vessel to pour
water through the WATER REFILL Opening until the water level
reaches the Maximum Fill Line on the Water Window. Once the
Steamer Base has been refilled, the Steamer will stop beeping
and will resume steaming for the remaining cooking time.
7. After cooking is complete, three audible beeps will sound and
the Food Steamer will automatically enter into the Keep Warm
Mode. The Display will show like in Figure 4.
Figure 4
NOTE: The default “Keep Warm” time is set for 60 minutes, and
will begin counting up from “0” in the Display. After 60 minutes,
the Steamer will shut off automatically.
10
8. Use protective oven mitts to remove the Lids and check the
food for desired doneness. Press the ON/OFF button to shut
off the Steamer – the red Power Light will turn off. If the food
needs more steaming, replace the Lids and repeat steps 2-6
to reset the cooking time.
Setting the Same Cooking Time for all 3 Steamer Bowls
When the Food Steamer is in Standby Mode (Figure 2), hold
down the SET Button until all three “BOWL” icons are flashing in
the Display. Press the + and – Buttons until the desired cooking
time is reached, and then press the SET Button to confirm.
The Steamer will not start cooking until the ON/OFF Button
is pressed.
When in Standby Mode, the display will look like that in Figure1.
To return to Standby Mode press the SET Button once; this will
clear the Display and then hold down the SET Button until all
three “BOWL” icons are flashing in the Display.
NOTE: To adjust any one of the cooking times, press the BOWL
SELECT Button until the desired Steamer Bowl is selected, then
use the + and – Buttons to revise the cooking time. Press the
SET Button again to confirm.
WARNING: Steam is hot and can cause burns. Keep
hands and face away from steam vents in the Lids.
Use protective oven mitts to remove Steamer Bowls from
the Base and to remove the Lids. When removing the
Lids after steaming, always tilt lid away from your face
to avoid burns caused from steam.
11
USER MAINTENANCE INSTRUCTIONS
Care and Cleaning
CAUTION: Unplug and allow Steamer and water to
cool completely before emptying water from the Drip Tray
and Steamer Base and before cleaning. Do not immerse
cord, plug, or Steamer Base with Heating Elements in
water or other liquids.
IMPORTANT: Always empty and clean the Steamer Base and
Drip Tray after every use.
1. Make sure that the red Power Light is off and then unplug the
Steamer from the wall outlet.
2. Allow the Lids, Steamer Bowls, Drip Tray, Steam Rings,
Steamer Base and water to cool completely before cleaning.
3. Lift the Steamer Bowls and Drip Tray off of the Steamer Base.
Remove the Steamer Bowls and tilt the Drip Tray over the
sink to pour out any water that has collected.
4. Remove the Steam Rings out of the Steamer Base and then
tilt the Steamer Base over the sink to pour out of the back
right corner any remaining water.
5. Wash Steamer Bowls, Lids, Cooking Bowl, Drip Tray and
Steam Rings in mild dishwashing detergent. Rinse and
dry thoroughly.
NOTE: Removable parts are dishwasher-safe (top rack only).
6. Clean the Steamer Base with a soft, damp cloth and
dry thoroughly.
12
Loading...
+ 33 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.