Toa VM-300SV User Manual

END OF LINE UNIT

INSTALLATION MANUAL

VM-300SV

Thank you for purchasing TOA's End of Line Unit. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.

1. SAFETY PRECAUTIONS

• Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation.

• Be sure to follow all the precautionary instructions in this section, which contain important warnings and/or cautions regarding safety.

• After reading, keep this manual handy for future reference.

5. SPECIFICATIONS

Note: The design and specifications are subject to change without notice for improvement.

Power Source Supplied from VM-3240VA/3360VA/3240E/3360E Power Consumption 0.2 W Speaker Line Input (CN 1)

Screw connector, Applicable cable diameter: AWG 24 – AWG 19

Contact Output (CN 2) Connected to the emergency contact input of

VM-3240VA/3360VA/3240E/3360E Connection cable: Twisted pair cable (shielded type is recommended) Screw connector, Applicable cable diameter: AWG 24 – AWG 19

Speaker Line Max. load: 100 W

Note: applicable only to 100 V speaker line

Dimensions 70 (w) x 18 (h) x 45 (d) mm (2.76" x 0.71" x 1.77") Weight 20 g (0.71 oz)

133-41-077-80

URL: http://www.toa.jp/

Traceability Information for Europe (EMC directive 2004/108/EC)

Manufacturer:

TOA Corporation 7-2-1, Minatojima Nakamachi, Chuo-ku, Kobe, Hyogo, Japan

Authorized representative:

TOA Electronics Europe GmbH Suederstrasse 282, 20537 Hamburg, Germany

4. CONNECTION

Indicates a potentially hazardous situation which, if mishandled, could result in moderate or minor personal injury, and/or property damage.

CAUTION

• Do not connect the speaker line to the contact output as doing so may result in fire or electric

shock.

• As up to 100 V is applied to the CN 1 terminal, never touch its terminal to avoid electric shock.

Leave all cable connections on the unit to a professional electrical contractor.

2. GENERAL DESCRIPTION

VM-3000 detects speaker line short circuits and open circuits by monitoring the terminated resistance value of the End-of-line (EOL) unit. Connecting the VM-300SV unit to the end of the speaker line eliminates the necessity of using the speaker line for line monitoring.

Note: This unit can only be used on a VM-3000 system with a firmware of 2.00 or later.

3. HANDLING PRECAUTIONS

• Do not install the unit in locations exposed to the direct sunlight or heaters, as the unit could be

deformed or discoloured.

• Avoid installing or storing the unit in dusty or humid locations, as doing otherwise could cause the

unit's failure.

• Keep a unit as far away as possible from a fluorescent lamp, digital equipment, PC or other

equipment which generate high frequency noise.

• Because the unit is not "hot-pluggable," the system needs to be shut down when it is installed or

removed.

• Note correct polarity (positive and negative orientation) when connecting Contact output.

Reserved polarity connections will cause failure.

To one of the VM-3240VA/ 3360VA/3240E/3360E's Emergency control inputs (1 – 5)

CAUTION

Do not connect the speaker line.

VM-300SV

CN2

CN1

C E

* Speaker line (E) may not

Speaker line (H)

Speaker line (C)

Speaker line (E)*

be connected.

CAUTION

Never touch after connection.