TJERNLUND 950-8302 T-STAT KIT 8504132 User Manual

(950-8302) CRAWL SPACE VENTILATOR T-STAT REPLACEMENT KIT

Disconnect power or unplug 115 VAC power cord before
servicing the Crawl Space Ventilator.

1. Remove Crawl Space Ventilator from wall. IMPORTANT: Note set-
ting of dehumidistat (if equipped) so it can be reset when finished.
Remove BLACK T-stat leads.

2. Use caution and drill out (2) T-stat rivets from exterior mounting
plate with a 5/32” drill bit, (See Diagram A).

3. Insert (2) 6-32 x 1/4” studs through mounting plate and T-stat and
tighten keps nuts. Replace BLACK T-stat leads.

4. Reinstall Crawl Space Ventilator in opening.

5. Reestablish 115 VAC power and cycle Crawl Space Ventilator “on” to verify proper operation. Reset dehumidistat (if equipped).
NOTE: If outside temperature is below 50

o

F, T-stat may not allow Ventilator to turn on.

Rev. 10/06 Copyright © 2006, Tjernlund Products, Inc. All rights reserved. P/N 8504132

TJERNLUND PRODUCTS, INC.

1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE [phone] • [phone] • FAX [phone]
Visit our web site • www.tjernlund.com

EXTERIOR VIEW

Model V1 Shown

Drill out (2) T-stat
rivets on exterior
mounting plate with
5/32” drill bit.

DIAGRAM A