Timex TK36 Owner Manual

Model TK36KT

Alarm Clock Radio

For additional information, online registration,
and exclusive special offers visit our website:

www.timexaudio.com

For questions or comments regarding this or other products,
please call our toll-free number 1-800-888-4491.

Para instruccionese en Espanol, llame al 1-800-888-4491.

Maintenance and Setup

1. Place the clock on a level surface away from direct sunlight or
sources of excessive heat.

2. Protect your furniture when placing the unit on natural wood or wood
with a coated finish. A cloth or other protective material should be
placed between the unit and the furniture.

3. Clean the casing with a soft cloth moistened only with mild soap
and water. Stronger cleaning agents are not recommended, as they
may damage the surface of the case.

4. If the unit is not to be used for a prolonged period, such as a month
or longer, remove the batteries to prevent possible corrosion. Should
the battery compartment become corroded or dirty, clean the
compartment thoroughly and replace all the batteries.

Battery Installation

This alarm clock radio operates on 2 “AA” batteries.

Note: Batteries should only be installed by an adult.

Installing the Batteries

1. The  Battery Compartment is located

on the back of the cabinet. Turn the clock
around and open the compartment latch.

2. Install 2 “AA” batteries (not included),

making sure the polarities match the
diagram printed inside the compartment.

3. Close the door, making sure it clicks shut,

and return the clock to its standing position.

For the Best Battery Performance

• We recommend using alkaline batteries.

• Non-rechargeable batteries are not to be recharged.

• Remove rechargeable batteries from the clock before charging.

• Do not mix different battery types, including new and used batteries.

• Only use batteries of the same or equivalent type.

• Remove exhausted batteries from the clock.

• Do not short-circuit the supply terminals.

• Batteries should always be removed if the clock is not going to be

used for an extended period of time (approximately 30 days or more)
to prevent leakage or damage.

Battery Compartment

Controls and Indicators

3

2

4

.

.

.

.

.

.

.

.

94

88

100

.

.

.
.

.

.

Setting the Clock and Alarm Times

Band Switch 

Volume Dial

Volume Control 

Clock-Set



Thumbwheel

Alarm-Set 
Thumbwheel

Battery Compartment

Snooze/Backlight



Button



Mode Switch



Radio Dial

 Tuning Control

 Alarm Hand

Setting the Clock Time

Rotate the  Clock-Set Thumbwheel control to set the clock
to the current time.

Setting the Alarm Time

Rotate the  Alarm-Set Thumbwheel control to position the



Alarm Hand to the desired alarm time.

Note: This is an analog clock, with a 12-hour display. The time

and alarm can not distinguish between AM and PM times, so if
the  Mode Switch is activated the alarm will sound during
both AM and PM times.

Operating the Alarm and Snooze Features

1. Set the alarm time as indicated in Setting the Alarm Time.

2. To wake to the radio, slide the  Mode Switch to the “Auto”
position. At the wake time, the alarm will sound at the set
radio station and volume (see Listening to the Radio).

3. To wake to the buzzer, slide the  Mode Switch to “Alarm.”

4. When the alarm sounds, you may turn it off or activate the
Snooze feature. To turn off the alarm, slide the  Mode
Switch to Off.

5. To use the snooze feature, press the  Snooze/Backlight
Button. The alarm will turn off for approximately four minutes
before sounding again. You may repeat this process several
times during the 36-minute snooze cycle.

Note: When the alarm sounds, it will play for a maximum of 40
minutes or until manually stopped before turning off automatically.
This cycle will repeat every 12 hours until the alarm is deactivated.

Listening to the Radio

1. Slide the  Mode Switch to the “On” position to turn on
the radio.

2. Select a station by sliding the  Band Switch to AM or FM
and rotating the  Tuning Control to the desired station.

3. Adjust the volume using the  Volume Control thumbwheel.

4. To shut the radio, slide the  Mode Switch to “Off.”

Note: This clock radio contains am AM internal bar antenna and
an FM wire antenna. For improved AM reception, rotate or move
the unit as needed until the signal comes in clearer. For improved
FM reception, unroll the wire antenna and position it as needed.

Operating the Backlight

This clock radio features a five-second, one-touch backlight for
easy night viewing. To activate the backlight, press the
 Snooze/Backlight Button. The light will shut off automatically.

Limited 90-Day Warranty Information

Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as
SDI Technologies), warrants this product to be free from defects in workmanship
and materials, under normal use and conditions, for a period of 90 days from the
date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to first return it
to the store where it was originally purchased.
and service still be required by reason of any defect or malfunction during the warranty
period,
charge (except for a $3.00 charge for handling, packing, return UPS/postage, and
insurance). This decision is subject to verification of the defect or malfunction upon
delivery of this product to the Factory Service Center listed below. The product must
include proof of purchase, including date of purchase. The fee for service after the
warranty period or without proof of purchase is $6.00.

Before returning this product for service, please first replace the batteries (if applicable)
with fresh ones, as exhausted or defective batteries are the most common cause
of problems encountered.

If service is still required:

1. Remove batteries (if applicable) and pack the unit in a well-padded, heavy

2. Enclose a photocopy of your sales receipt, credit card statement, or other proof

3. Enclose a check or money order payable to the order of Soundesign, for the sum

4. Send the unit prepaid to the Factory Service Center listed below:

NOTE: This warranty is valid only if the product is used for the purpose for which it
was designed. It does not cover (i) products which have been damaged by negligence,
misuse, or accident, or which have been modified or repaired by unauthorized
persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii)
damage to tape cassettes or compact discs (if applicable); (iv) the cost of shipping
this product to the Consumer Repair Department and its return to the owner.

This warranty is valid only in the United States of America and does not extend to
owners of the product subsequent to the original purchaser. Any applicable implied
warranties are also limited to 90 days, and SDI Technologies will not be liable for
consequential damages. (Some states do not allow limitations on implied warranties
or exclusion of consequential damages, so these restrictions may not apply to you.)
This warranty gives you specific legal rights; you may also have other rights which
vary from state to state.

For questions or comments regarding this or other products, please call our toll­free number: 1-800-888-4491.

TIMEX and TIMEX Kids are registered trademarks of Timex Corporation in the
United States and other countries.

SDI Technologies will repair or, at its discretion, replace this product without

corrugated box.

of the date of purchase.

of $3.00 (or $6.00 if after the warranty period or without proof of purchase).

Consumer Repair Department

SDI Technologies Inc.

Timex Audio Products Division

1401 Pullman Drive, Suite A

El Paso, TX 79936-7726

Should this fail to resolve the matter

TK36KT-031403-2 Printed in

China