Timex TK310 Owner Manual
Model TK310
Alarm Clock Radio
For additional information, online registration,
and exclusive special offers visit our website:
www.sdidirect.com
For questions or comments regarding this or other products,
please call our toll-free number 1-800-888-4491.
Para instruccionese en Espanol, llame al 1-800-888-4491.
AM/FM
Maintenance and Setup
1. Place the clock on a level surface away from direct sunlight or sources
of excessive heat.
2. Protect your furniture when placing the unit on natural wood or wood
with a coated finish. A cloth or other protective material should be
placed between the unit and the furniture.
3. Clean the casing with a soft cloth moistened only with mild soap and
water. Stronger cleaning agents are not recommended, as they may
damage the surface of the case.
4. If the unit is not to be used for a prolonged period, such as a month
or longer, remove the batteries to prevent possible corrosion. Should
the battery compartment become corroded or dirty, clean the
compartment thoroughly and replace all the batteries.
Power Operation
This alarm clock radio operates on either 3 “AA” batteries or an optional AC
adapter (not included).
Note: All power sources should be connected or installed by an adult.
Installing the Batteries
1. The Battery Compartment is on the bottom
of the cabinet. Gently turn the clock over and
open the compartment latch.
2. Install 3 “AA” batteries (not included), making
sure the polarities match the diagram printed
inside the Battery Compartment.
3. Close the door, making sure it clicks shut, and
return the clock to its standing position.
Connecting a AC Adapter
To power the clock using an optional AC adapter, connect your centernegative, 4.5V/300mA AC adapter to the DC Power Jack, then plug
the adapter into your wall outlet.
For the Best Battery Performance
•We recommend using alkaline batteries.
• Non-rechargeable batteries are not to be recharged.
• Remove rechargeable batteries from the toy before charging. (if removable)
• Do not mix different types of batteries, including new and used batteries.
• Only use batteries of the same or equivalent type.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
• Rechargeable batteries are only to be charged under adult supervision.
(if removable)
• Batteries are to be inserted with correct polarity.
Battery Compartment
Controls and Indicators
Setting the Clock and Alarm Times
Setting the Clock Time
Rotate the Clock-Set Thumbwheel control to set the clock
to the current time.
Snooze/Backlight
Button
Volume Control
Mode Switch
Alarm-Set
Thumbwheel
Clock-Set
Thumbwheel
AM/FM
CLOCK RADIO
Battery Compartment
Tuning Control
Alarm Hand
Band Switch
Setting the Alarm Time
Rotate the Alarm-Set Thumbwheel control to position the
Alarm Hand to the desired alarm time.
Note: This is an analog clock, with a 12-hour display. The time
and alarm can not distinguish between AM and PM times, so if
the Mode Switch is activated the alarm will sound during
both AM and PM times.
Operating the Alarm and Snooze Features
1. Set the alarm time as indicated in Setting the Alarm Time.
2. To wake to the radio, slide the Mode Switch to the “Auto”
position. At the wake time, the alarm will sound at the set
radio station and volume (see Listening to the Radio).
3. To wake to the buzzer, slide the Mode Switch to “Alarm.”
4. When the alarm sounds, you may turn it off or activate the
Snooze feature. To turn off the alarm, slide the Mode
Switch to Off.
5. To use the snooze feature, press the Snooze/Backlight
Button. The alarm will turn off for approximately four minutes
before sounding again. You may repeat this process several
times during the 40-minute snooze cycle.
Note: When the alarm sounds, it will play for a about 40 minutes
or until manually stopped before turning off automatically. This
cycle will repeat every 12 hours until the alarm is deactivated.
DC Power Jack
Loading...