Model T317
AM/FM Alarm Clock with
Digital Radio Display
9
10
8
11
54 62 78 110 140 170AM X10KHz
88 94 100 104 106 108FM MHz
7
AM/FM Clock Radio
12
6
1
2
3
4
5
Controls and Indicators
Snooze/Backlight
Button
Band Switch
Mode Switch
Tuning Control
11
54 62 78 110 140 170AM X10KHz
88 94 100 104 106 108FM MHz
10
12
1
2
Volume Control
3
9
Alarm Hand
4
8
6
7
Clock Radio
/FM
AM
5
Battery Compartment
Alarm-Set
Thumbwheel
Clock-Set
Thumbwheel
Dimmer Switch
AC Power Cord
Wire Antenna
Maintenance and Setup
1. Place the unit on a level surface away from direct sunlight or
sources of excessive heat.
Protect your furniture when placing the unit on natural wood
2.
or wood with a lacquered finish. A cloth or other protective
material should be placed between the unit and the furniture.
3. Clean the casing with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as thinner,
benzine, or similar materials are not recommended, as they
may damage the surface of the case.
4. If the unit is not to be used for a prolonged period, such as
a month or longer, remove the batteries to prevent possible
corrosion. Should the battery compartment become corroded
or dirty, clean the compartment thoroughly and replace all
the batteries.
Power Sources
Note: This alarm clock radio operates on two power sources:
one “AA” battery (included) for the clock, and AC power
for the radio and backlight. The clock and an alarm will
operate with only the battery. For full operation of all
features, both power sources must be in use.
1. Please see A Consumer Guide to Product Safety, specifically
the Polarization and Power-Supply Cord Protection notes,
for instructions on plugging in the AC Power Cord.
To Replace the Battery
1. Open battery compartment cover.
2. Install 1 “AA” battery, making sure
that the polarity is correct as shown
within the battery compartment.
3. Close the battery compartment
cover and latch securely.
Battery Compartment