User manual
DTI 2300
DTI 2305
3581493A DTI2300 UM2.qxd 18/10/2004 08:51 Page 1
CCoonntteennttss
AAcccceessssoorriieess
2 Accessories
3 Safety information
4 Connections
5 Remote control handset
6 Basic operation
7 Menu structure
8 Tuning the receiver
9 Advanced setup
2
Set-up
Power Cord
Remote Control
Scart Lead
10 Channel lists
11 Timer programming
12 Parental controls
13 Program guide
Upgrading your receiver
14 Trouble shooting and
information
15 Your guarantee
You can contact THOMSON by dialing : 01788 541970
(All calls are charged at Standard Rates)
2 x AAA
Batteries
DTI2300
User Manual
Quick Guide
Guarantee card
3581493A DTI2300 UM2.qxd 18/10/2004 08:52 Page 2
3
Congratulations on your choice of this state-of-the-art Digital Top Up TV ready and
Free to View Receiver. We hope you will enjoy all the new features this technology
brings to your home for many years. Your dealer should have checked your postcode
for reception, but the availability of Digital Signals does depend on the transmitter(s)
available to your receiving aerial. If you have any doubt about this availability, please
contact your dealer, or check the following internet websites:-
wwwwww..ttooppuuppttvv..ccoomm,, wwwwww..ffrreeeevviieeww..ccoo..uukk
or
wwwwww..ddttgg..oorrgg..uukk//ccoonnssuummeerr
If you experience reception problems contact our aerial helpline on
00880000 55442288226655
SSaaffeettyy iinnffoorrmmaattiioonn
IInnttrroodduuccttiioonn
In order that you may enjoy this product for a long time it is important that you observe the
following points when installing and operating your receiver
● This receiver is intended for the reception of TV picture and sound signals. Any other
application is expressly prohibited.
● Avoid the long-term display of static images, e.g. menus or audio only channels.
● Do not expose the receiver to any moisture. The receiver is intended for use in dry rooms.
If you wish to operate it in the open air, make absolutely sure that it is protected against
moisture (rain, splashes, etc.).
● Do not place any object filled with water (vases or similar) on the receiver.
● Place the receiver on a flat and hard surface. Do not place any objects (e.g. newspapers) on
the receiver.
● If placed in an enclosed unit, the all-round distance between the receiver and the sides of
the unit must be at least 10cm.
● Do not place the receiver in the immediate vicinity of a heat source or in direct sunlight as
this would prevent appropriate cooling.
● During a thunderstorm it is recommended that you disconnect the receiver from the mains
and aerial to prevent damage from lightning strikes.
● Never open the receiver as this will invalidate your guarantee.
● Do not dispose of used batteries in normal waste. Please dispose of them at appropriate
collection points.
● If you are not using the receiver for a long time (including overnight), please switch it off
at the mains. This saves energy. Note that any software upgrades can take place at night at
your request.
● This product has been constructed with the environment in mind. There is a minimum of
plastic parts and the packaging is largely made from recycled paper. It is also disassemblyfriendly allowing for easy recycling at the end of its life.
● CLEANING - Dust will collect on the unit and can be removed with dry clean cloth.
DDoo nnoott
spray any substance on the unit.
● CARD - Avoid removing and re-inserting the card unnecessarily, handle with care and do
not clean the card with chemicals.
Set-up
3581493A DTI2300 UM2.qxd 18/10/2004 08:52 Page 3
How to connect the aerial, scart and co-axial cables
Caution : Always disconnect the receiver from the mains supply before you connect it
to any other equipment.
X Unplug the aerial lead from your VCR (or TV) and connect it to the »RF IN« socket on the
rear of the receiver.
Y If connecting to a VCR, connect the aerial fly-lead that came with your VCR between
»
LLOOOOPP TTHHRROOUUGGHH OOUUTT
« on the receiver and aerial IN on the VCR.
Z Connect the scart lead from the »
TTVV SSCCAARRTT
« socket on the receiver to the AV1/EXT1/AUX1
scart IN on your TV.
[ Plug the power connector into the »
MMAAIINNSS IINNPPUUTT
« socket on the receiver.
\ If you have a Top Up TV smart card, insert it into the slot with the gold square facing
ddoowwnn
.
If you wish to connect the audio outputs to your Hi-Fi or AV amplifier, you will need to
purchase the necessary phono cables and connect them as shown above.
Note: If you wish to continue watching analogue TV on your television, you must
purchase an aerial fly-lead and connect it between the aerial IN on the TV and the
aerial OUT on the VCR (or the »
LLOOOOPP TTHHRROOUUGGHH OOUUTT
« on the receiver)
It is strongly recommended that the product be connected via scart leads to your TV
and VCR.
TV
Aerial
TV
VCR
AUX IN
LR
DIGITAL IN
RF IN
RF LOOP
THROUGH
TV
MAINS
INPUT
RECEIVER
VCR
L
R
DIGITAL
AUDIO OUT
AV AMPLIFIER
v
w
x
u
Aerial Leads
(not supplied)
Scart Leads
(1 supplied)
Note : For best results
connect the STB to the TV
using the scart lead supplied.
AV1
EXT1
AUX1
OUT
IN
IN
OUT
Not supplied - purchase separately if required
Not supplied
AUX
VIDEO
EXT
Phono Leads
(not supplied)
Supplied with VCR
CCoonnnneeccttiioonnss
4
Set-up
3581493A DTI2300 UM2.qxd 18/10/2004 08:52 Page 4
Point the remote control at the receiver and press the STB button.
If you have a compatible Thomson TV or DVD player, you can operate some of its
features by pointing the handset at it and pressing the TV or DVD button. The handset
will then work the TV or DVD until you press the STB button again.
RReemmoottee ccoonnttrrooll
Set-up
uvw
B
aanndd tthhee pprrooggrraamm Saanndd TTbbuuttttoonnss ccaann aallssoo bbee ffoouunndd oonn tthhee rreecceeiivveerr ffrroonntt ppaanneell..
5
SSTTBB//DDVVDD//TTVV KKeeyyss
select and turn on the device you
want to control. Will also change
selection on a Thomson AV amplifier
aa
+ / aa-
Adjust audio volume level.
cc
Mute/Unmute audio.
EEXXIITT
To exit a menu or get back
in a sub-menu.
UUpp//DDoowwnn aarrrroowwss
Move up and down through the menu.
Up arrow selects info menu.
LLeefftt//RRiigghhtt aarrrroowwss
Move left and right through the
menu.Also provides Active Zoom feature
in live video mode.
AAVV
Switch between digital TV and analogue
TV or VCR (when VCR is in play)
DDVVDD sshhoorrttccuuttss kkeeyyss
Control directly the DVD player even if
you are in TV or DVD mode on your
remote control unit.
BB
Turns the receiver On/Off (stand by
mode). Press twice for Thomson system
Off. To activate very low power
standby, press & hold for a few seconds.
(indicated by the red light going dim)
To switch back on use the key on the unit.
PPRR++ // PPRR--
Program + / Program GGUUIIDDEE
Electronic Program Guide
MMEENNUU
Access the Main menu.
OOKK
Confirm a choice. Also displays channel
and favourite list selection menu.
TTEEXXTT
Display text / interactive pages if available.
CCoolloouurr kkeeyyss
Context dependant function keys.
NNuummeerriicc KKeeyyss ((00--99))
Controls the numerical operations and
especially changes program Directly.
SSUUBBTTIITTLLEESS
Turn subtitles ON/OFF.
Note:
Other keys not mentioned above have no function on this model.
3581493A DTI2300 UM2.qxd 18/10/2004 08:52 Page 5
Loading...