The Singing Machine SML385U User Manual

TM
SML385UBK / SML385UW
INSTRUCTION MANUAL/ MANUAL DE INSTRUCCIONES
/ MODE D’EMPLOI
www.singingmachine.com
The Singing Machine® is a registered trademark of The Singing Machine Co., Inc.
The Singing Machine® es marca registrada de The Singing Machine Co., Inc.
— E1 —
Warnings
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The Caution
marking is located on the bottom panel.
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
ATTENTION: The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying this product.
FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
INDUSTRY CANADA NOTICE:
This device complies with Industry Canada Iicense-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
DRIPPING WARNING: This product shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the product.
VENTILATION WARNING: The normal ventilation of the product shall not be impeded for intended use.
THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR CHAPTER 1, SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURED.
Warnings:
• This CD player employs a laser light beam. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.
• The use of controls, adjustments, or procedures other than those specified herein might result in hazardous radiation exposure.
• The apparatus shall be used in an open area.
CAUTION!
Invisible laser radiation when open and interlocks defeated. Avoid exposure to beam.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The rating information is located at the back of the unit.
Important Safety Information
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the Manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Do not place objects filled with water, such as a vase, on the apparatus.
16. The AC mains plug is used as the power disconnect device and it should remain readily accessible and operable during intended use. In order to completely disconnect the apparatus from power, the mains plug should be completely removed from the AC outlet socket.
17. CAUTION: To reduce the risk of fire or explosion, do not expose batteries to excessive heat such as sunshine, fire or other heat sources.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
— E2 —
Included
Please make sure that the following items are included.
Wired Microphone
Main Unit
AC Adapter
Audio/Video Cables
Manual
— E3 —
Location of Controls (Top/Front)
1. LED Display
2. CD Door
3. MASTER VOLUME Control
4. CDG/BT/USB Button
5. Skip Button
6. Play/Pause
Button
7. Skip Button
8. Skip +10 Button
9. Stop
/Pair Button
10. REPEAT/PROGRAM Button
11. DISCO LIGHT Slide Switch
12. PROGRAM indicator
13. Mic Holders
14. MIC Volume Control
15. ECHO Control
16. REPEAT indicator
17. MIC 2 Jack
18. ON/OFF indicator
19. Power ON/OFF Button
20. Record indicator
21. Record Button
22. USB slot
23. Auto Voice Control
24. PLAY/PAUSE indicator
22. BALANCE Control
23. CDG indicator
24. MIC 1 Jack
25. Balance Button
26. CDG indicator
27. MIC 1 Jack
28. Speaker
u w x y U V
W X at ak
am
am
bl
al
an ao ap
aq
as
ar
bt bk
bm
bp
bn
bq
bo
br
v
— E4 —
Location of Controls (Rear)
26. VIDEO OUT Jack
27. LINE IN Jack
28. AUDIO OUT Jack (R)
29. DC IN Jack (5.8V)
30. AUDIO OUT Jack (L)
bp
br
bq
bs
ct
— E5 —
Connection
Connecting the Microphone(s)
Microphones:
Connect a microphone into Mic jack 1 u as well as Mic jack 2 v (when desired).
Note: Do not drop or tap the Mic as damage to the Mic or speakers may occur. Do not twirl the microphone cord as it will cause damage to the encased wiring.
Connecting the Unit to a TV
VIDE O INPUT
AUDIO INPUT
R L
RCA cables
VIDE O OUT
(yellow)
AUDIO OUT
(white - L
red - R)
REAR VIEW OF TV
To output the video, lyrics and audio to your TV, perform the following steps:
Connect the RCA video cable (Yellow) to the VIDEO OUT jack and the audio cables (White and Red) to the AUDIO OUT jacks located on the back of the Singing Machine.
Connect the opposite end of the RCA video cable (Yellow) to the VIDEO IN jack and the audio cables (White and Red) to the AUDIO IN on your TV.
Notes:
• This unit can be used with or without a TV, but it is highly recommended to use a TV in
order to utilize all the features.
• Also refer to the TV’s User Guide.
• To see the lyrics on the screen, you must use a CD+G disc or MP3+G files.
uv
— E6 —
Connection
Connecting to AC Power
Connecting to Line In Jack
Insert the AC power cord into a conveniently located AC outlet having 120V AC, 60Hz.
Note:
Make all connections before connecting to AC power.
Connect an external device by using an appropriate cable (3.5mm audio cable not included) as shown.
Note:
See page E13 to select and use the Line In function.
LINE IN
To External Unit
AUDIO OUTPUT
/ HEADPHONE JACK
Disco Lights
1
To illuminate the disco light and get
your desired lighting effect, slide the Disco Light slide switch from the OFF position to your desired level.
u
— E7 —
Operation
Playing a CDG
1
Connect the unit as described previously;
if using a CD+G, it is recommended to connect to a TV. Press the ON/OFF button to turn the unit on.
2
Lift open the CD door and insert a CD
or a CD+G by gently pressing it on the center spindle. Then close the CD door.
Note:
What is a CD+G?
A CD+G (CD+Graphics) is the standard
format for most karaoke discs that will display the words on the screen.
3
Repeatedly press the CDG/BT/USB
button to select the CDG/CD mode; “--” will appear when searching the disc and then the total number of tracks will appear. When a CDG disc is inserted, the CDG indicator will light.
4
Press the PLAY/PAUSE
button to start playback; if listening to a CD+G file, the image and lyrics will appear on the TV screen (if connected) and the PLAY/ PAUSE Indicator will light.
u
v
w
x
Loading...
+ 16 hidden pages