The Singing Machine SML343 BK/P Instruction Manual
SML343(BK/P)
INSTRUCTION MANUAL
Please read before first using this unit.
The Singing Machine® is a registered trademark or The Singing Machine Co., Inc.
SML343-ENG(2014).qxp_Layout 1 7/7/14 16:25 Page 1
E - 1
Warnings
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
R
EMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The Caution marking is located on the bottom panel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol
w
ithin an equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the product’s
enclosure that may be of sufficient magnitude to constitute a risk of
e
lectric shock to persons.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT AND FULLY INSERT.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
Class II equipment symbol.
This symbol indicates that the unit has a double insulation system.
ATTENTION: The exclamation point within an equilateral triangle is
i
ntended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying
this product.
D
ANGER: This symbol is intended to alert the user to the risk of
exposure to invisible and hazardous laser radiation if the cover or back
is opened, the interlock fails or is defeated. Direct exposure to the
b
eam may damage your eyesight.
FCC WARNING: This equipment may generate or use radio frequency
e
nergy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
e
quipment if an unauthorized change or modification is made.
T
his device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
i
ncluding interference that may cause undesired operation.
LASER SAFETY: This unit employs a laser. Only qualified service personnel
should attempt to service this device due to possible eye injury.
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE
PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
INDUSTRY CANADA NOTICE
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
DRIPPING WARNING: This product shall not be exposed to dripping or splashing,
and no objects filled with liquids, such as vases, shall be placed on the product.
V
ENTILATION WARNING: The normal ventilation of the product shall not be
impeded for intended use.
SAFETY VERIFICATION: This device is made and tested to meet safety standards
of the FCC, requirements and compliance with safety performance of the U.S.
Department of Health and Human Services and also with FDA Radiation
Performance Standards 21 CFR Subchapter.
N
OTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
i
nterference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
c
ommunications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
t
urning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
• The rating information is located at the bottom of the unit.
CAN ICES-3(B)/NMB-3(B)
Important Safety Information
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance
with the Manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or groundingtype plug. A polarized plug has two blades with one wider than the
other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your
safety. When the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart , stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms
or when unused for long periods of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped.
15. WARNING: To reduce the risk of fire or electric shock, do not expose
this apparatus to rain or moisture. Do not place objects filled with
water, such as a vase, on the apparatus.
16. The AC mains plug is used as the power disconnect device and it
should remain readily accessible and operable during intended use.
In order to completely disconnect the apparatus from power, the
main plug should be completely removed from the AC outlet socket.
17. CAUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other heat
sources.
SML343-ENG(2014).qxp_Layout 1 7/7/14 16:25 Page 1
E - 2
CONTROL LOCATIONS
FRONT VIEW
REAR VIEW
1
. Handle
27. VIDEO OUT jack
28. AUX OUT Jack (R )
29. AUX OUT Jack (L )
30. DC IN Jack
2. Disco Light bu tto n
3
. ON/OFF LED
4
. ON/OFF butto n
5. Disco light s
6
. PLAY/PAUSE b utt on
8. SKIP button
7
. STOP button
9. SKIP button
10. REPEAT but ton
11. PROGRAM bu tto n
12. Display
14. AUX IN jac k
15. MIC 2 jack
16. MIC 1 jack
13. Speaker
C
D door .17
Master Volume con tro l . 18
ECHO control . 19
Auto Voice Con tro l . 20
BALANCE contro l . 21
MIC Volume con tro l . 22
Battery Door . 31
PROGRAM LED .2 4
CDG LED .23
PLAY/PAUSE LED .2 5
REPEAT LED .26
SML343-ENG(2014).qxp_Layout 1 7/7/14 16:25 Page 2
E - 3
CONNECTIONS
INSTALLATION OF BATTERIES
DC OPERATION
1. Slide the battery door in the direction the arrows to reveal the
battery compartment. Insert eight (8) “C” size alkaline batteries
(not included) as indicated on the diagram.
2. Replace cover tightly before operating.
CAUTIONS:
• Replace all batteries at the same time.
• Do not mix old batteries with new batteries.
Battery Precautions
The precautions below should be followed when using batteries in
this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the
batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline
and Carbon Zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged,
they can overheat and rupture. (Follow battery manufacturer’s
directions.)
6. Rechargeable batteries are to be removed from the product
before being charged.
7. Rechargeable batteries are only to be charged under adult
supervision.
8. Exhausted batteries are to be removed from the product.
9. Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
CONNECTING THE POWER
Insert the DC adapter into the DC jack. You can power the system from a standard AC outlet by using the
supplied Power Adapter (The adapter operates on AC 100V~240V /50Hz-60Hz).
CAUTIONS:
• The included AC adapter is for use with this unit only. Do not
use it with other equipment.
• When the adapter is plugged in, the equipment is not
completely disconnected from the main source of power that
runs from the outlet to the unit. This occurs even when the
power button on the unit is placed on the off position.
Disconnect the power plug from the wall outlet to ensure
that the equipment does not receive any power source.
SML343-ENG(2014).qxp_Layout 1 7/7/14 16:25 Page 3
Loading...