Thermo King ClimaAIRE BEA114 Operator's Manual

Alarms

The Alarm LED will illuminate in the following two conditions:

• high or low pressure switches are off longer than 10 minutes

• high or low pressure switches are off 5 times per 10 minutes
(flash on and off).

In both cases, the unit will switch to the Ventilation mode.
To restart the unit, press twice the key ON/OFF (1) to switch OFF

and ON the unit.

Warranty Instructions

Should you require warranty service during the warranty period,
simply present your copy of the Warranty Certificate at any of the
dealer locations shown in the Thermo King Service Directory.
Terms of the complete Thermo King Corporation Warranty are
available on request.

Controller

Operator’s

Manual

Control Panel Descriptions

Operating Instructions

Alarms

ATTENTION: If the alarm comes up again, don’t
restart and see your nearest dealer for service.

CAUTION: The unit can automatically start and run
anytime the ignition key is in the ON or OFF position.
No matter if the ON/OFF switch is ON or OFF
(depends on setup program).

AJA831

BEA114

TK 51711-3-PC (10-05)
Copyright © 2005 Ingersoll-Rand Climate Control ESA

CAUTION: This is a driver’s reference guide.
If further information is required, consult your
Thermo King service directory for the location
and phone of the local dealer.

Operating Instructions

Turn the system ON by pressing key ON/OFF (1).
Use the keys MODE (2), SPEED (3) and AIR MODE (4) to adjust

the system. By pressing the selection key you select one of the
options in the same group.

In Auto Mode all functions are controlled by the ClimaAIRE
controller automatically according to the required setpoint.

Turn the system OFF by pressing key ON/OFF (1).

Control Panel Descriptions

ON/OFF

(1)

MODE

(2)

SPEED

(3)

AIR MODE

(4)

THERMOSTAT

(5)

AJA831

(1) ON/OFF KEY
To turn the unit ON, press the key.

To turn the unit OFF, press the key again.

(2) COOL / HEAT MODE SELECTION KEY
Reheat / Auto Mode: The unit will cool or heat the bus

automatically (according to thermostat requirements).

A/C Mode: The unit will operate in cool mode.
Heat Mode: The unit will operate in heat mode.
Ventilation Mode: Only the blowers are operating.

(3) BLOWER SPEED SELECTION KEY
Automatic Blower Speed: The blowers are controlled

automatically depending on the thermostat setpoint and
passenger compartment conditions.

High Blower Speed.
Medium Blower Speed.
Low Blower Speed.

(4) FRESH OR RECIRCULATED AIR SELECTION KEY
Automatic: Fresh air is automatically controlled in

passenger compartment.

Fresh Air damper is open.
Recirculated Air: Fresh air damper is closed.

(5) THERMOSTAT

To cool the passenger compartment, turn the knob to the
LEFT. To warm the passenger compartment, turn the knob to
the RIGHT.

The inside temperature range is 17 - 27 C (63 - 80 F).