Thermador MCES, MCT27ES, MCT30ES Installation Instructions

INSTALLATION MANUAL
Built-In Microwave Oven Trim Kits
MANUEL D'INSTALLATION
Kits de garniture pour four à micro-ondes encastré
MANUAL DE INSTALACIÓN
Conjuntos de molduras para hornos de microondas empotrados
MCES
Trim Kit Models/ Modèles pour kits de garniture / Modelos de conjuntos de molduras:
MCT27ES MCT30ES
Table of Contents
Questions?
1-800-735-4328
www.thermador.com
We look forward to hearing from you!
This Thermador Appliance is made by
BSH Home Appliances Corporation
5551 McFadden Ave.
Huntington Beach, CA 92649
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Before you Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Trim Kits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Combination with Wall Ovens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Tools and Parts Needed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Parts Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Power Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Cabinet Cutout Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Outlet Area . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Prepare the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Prepare Cabinet Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Connect to Electricity and Install the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Before Calling Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Data Plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Safety
Important Safety Instructions
m
READ AND SAVE THESE INSTRUCTIONS
WARNING:
m
When properly cared for, your new appliance has been designed to be safe and reliable. Read all instructions carefully before use. These precautions will reduce the risk of burns, electric shock, fire and injury to persons. When using kitchen appliances, basic safety precautions must be followed, including those in the following pages.
WARNING:
m
APPLIANCE HANDLING SAFETY
Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance.
Do not repair or replace any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing should be done by a qualified technician.
ELECTRIC SAFETY
Before you plug in an electrical cord, be sure all controls are in the OFF position.
Do not plug the microwave into the wall until after the installation is complete. This is to prevent accidentally turning the microwave on during the installation.
For appliances equipped with a cord and plug, do not cut or remove the ground prong. It must be plugged into a matching grounding type receptacle to avoid electrical shock. If there is any doubt as to whether the wall receptacle is properly grounded, the customer should have it checked by a qualified electrician.
If required by the National Electrical Code (or Canadian Electrical Code), this appliance must be installed on a separate branch circuit.
Installer - show the owner the location of the circuit breaker or fuse. Mark it for easy reference.
Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical connections and grounding must comply with all applicable codes.
SAFETY CODES AND STANDARDS
This appliance complies with one or more of the following Standards:
UL 858, The Standard for the Safety of Household Electric Ranges
UL 923, The Standard for the Safety of Microwave Cooking Appliances
UL 507, The Standard for the Safety of Electric Fans ANSI Z21.1, The American National Standard for
Household Cooking Gas Appliances CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators CAN/CSA-C22.2 No. 61-M89 Household Cooking
Ranges
It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations.
RELATED EQUIPMENT SAFETY
Remove all tape and packaging before using the appliance. Destroy the packaging after unpacking the appliance. Never allow children to play with packaging material.
Never modify or alter the construction of the appliance. For example, do not remove panels, wire covers or anti-tip brackets/screws.
MICROWAVE SAFETY
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the door open.
English 1
(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary:
(e) A microwave leakage check to verify compliance with the Federal Performance Standard should be performed on each oven prior to release to the owner.
(1) interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other
damage), (4) damage to or loosening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity, and connection.
(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before the oven is released to the owner.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING:
Improper use of the grounding can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded, and:
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the appliance.
Installation
Before you Begin
Trim Kits
CAUTION:
m
30” Cabinet MCT30ES MCES 27” Cabinet MCT27ES MCES
Trim kits are designed for use only with the Thermador microwave oven models listed in Table 1.
For safety, do not alter or modify any part of this kit or oven.
Unit is heavy and requires at least two people to lift or move.
Trim Kits
Microwave
Ovens
Combination with Wall Ovens
Your microwave oven can be installed into a cabinet or wall by itself or above any 27" or 30" Thermador single wall oven.
WARNING:
m
To reduce the risk of fire and electric shock, install microwave at least 3/4” above designated oven.
Tools and Parts Needed
Phillips head screwdriver
Measuring tape
Drill with bits (1/16”)
Pliers
Table 1: Trim kits for microwave ovens.
English 2
9/16” Socket, Extension and Wrench
Parts Included
D
A
B
C
H
G
I
J
E
F
Parts Included
A Philips Head Wood Screws (8) B Philips Head Tapping Screws (5) C Adhesive Tape D Faceplate Fixing Brackets (2)* E Hex Head Bolts (4) F Base Supports (2) G Air Ducts (2) H Cabinet Fixing brackets (2)
I Faceplate
*May be included with the faceplate in some
models.
Power Requirements
Electrical specifications: 120V, 18A, 60Hz.
The outlet must be properly grounded in accordance with all applicable codes. It can be installed in the backwall directly behind the oven.
J Baseplate
English 3
Cabinet Cutout Dimensions
min 21"
(533 mm)
25 7/16"
(646 mm)
min 36 1/16"
(916 mm)
19 7/8"
(504 mm)
27” Appliances
30” Appliances
27” Appliances 30” Appliances
19 7/8"
(504 mm)
min 36 1/16"
(916 mm)
28 7/16"
(722 mm)
min 21"
(533 mm)
Outlet Area
The outlet can be located anywhere within the shaded area.
7"
(178 mm)
2 1/2"
(64 mm)
8 1/2"
(216 mm)
2 1/2"
(64 mm)
English 4
Installation Procedure
Prepare the Appliance
Using pliers, rotate as you pull out to remove the plastic microwave feet. Prepare the appliance according to Figures 1 to 6.
Figure 1
Figure 3
Figure 4
Figure 2
NOTE:
Dispose of rear cover and reuse screws on next steps.
English 5
Figure 5
Figure 6
English 6
Prepare Cabinet Cutout
a=b
Prepare cabinet cutout according to Figures 7 to 8.
Figure 7
dia. 1/16"
a
b
English 7
Figure 8
dia. 1/16"
NOTE:
A block of wood may need to be added behind the cabinet front, flush with the cabinet opening, to secure the bracket.
Figure 9
Connect to Electricity and Install the Appliance
NOTE:
Two people may be needed for this installation.
Insert plug into three-prong, grounded outlet according to Figure 9. See “Power Requirements” on page 3 for electrical specifications.
Slide the unit back so that the base supports fit into the rear brackets. Fit the appliance according to Figures 10 to 14.
English 8
Figure 10
Figure 11
Figure 13
123
NOTE:
Brackets may be included with the faceplate in some models.
To install, tilt and push down bracket into the snaps, and secure into position.
Figure 12
Figure 14
NOTE:
Do NOT clean decorative trim with abrasive cleaners.
English 9
Service
Data Plate
Before Calling Service
Please be prepared with the information printed on the data plate before calling service.
Data Plate
Keep your invoice or escrow papers for warranty validation if service is needed.
English 10
Loading...
+ 28 hidden pages