Texas Instruments UA9638CP, UA9638CDR, UA9638CD Datasheet
uA9638C
DUAL HIGH-SPEED DIFFERENTIAL LINE DRIVER
SLLS112C – OCTOBER 1980 – REVISED APRIL 1994
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
D
Meets or Exceeds ANSI Standard
EIA/TIA-422-B
D
Operates From a Single 5-V Power Supply
D
Drives Loads as Low as 50 Ω up
to 15 Mbps
D
TTL- and CMOS-Input Compatibility
D
Output Short-Circuit Protection
D
Interchangeable With National
Semiconductor DS9638
description
The uA9638C is a dual high-speed differential line driver designed to meet ANSI Standard EIA/TIA-422-B. The
inputs are TTL and CMOS compatible and have input clamp diodes. Schottky-diode-clamped transistors are
used to minimize propagation delay time. This device operates from a single 5-V power supply and is supplied
in an 8-pin package.
The uA9638 provides the current needed to drive low-impedance loads at high speeds. Typically used with
twisted-pair cabling and differential receiver(s), base-band data transmission can be accomplished up to and
exceeding 15 Mbps in properly designed systems. The uA9637A dual line receiver is commonly used as the
receiver. For even faster switching speeds in the same pin configuration, see the SN75ALS191.
The uA9638C is characterized for operation from 0°C to 70°C.
logic symbol
†
†
This symbol is in accordance with ANSI/IEEE Std 91-1984 and
IEC Publication 617-12.
2A
1A
5
6
7
8
2Z
2Y
1Z
1Y
3
2
logic diagram
2Z
2Y
1Z
1Y
3
2
2A
1A
5
6
7
8
Copyright 1994, Texas Instruments Incorporated
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
National Semiconductor is a trademark of National Semiconductor Corporation.
1
2
3
4
8
7
6
5
V
CC
1A
2A
GND
1Y
1Z
2Y
2Z
D OR P PACKAGE
(TOP VIEW)
uA9638C
DUAL HIGH-SPEED DIFFERENTIAL LINE DRIVER
SLLS112C – OCTOBER 1980 – REVISED APRIL 1994
2
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
schematics of inputs and outputs
V
CC
EQUIVALENT OF EACH INPUT
TYPICAL OF ALL OUTPUTS
Input
4 kΩ NOM
V
CC
Output
GND
9.6 Ω NOM
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
†
Supply voltage range, V
CC
(see Note 1) –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input voltage range, V
I
–0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous total power dissipation See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating free-air temperature range, T
A
0°C to 70°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
–65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1,6 mm (1/16 inch) from 10 seconds 260°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: Voltage values except differential output voltages are with respect to network GND.
DISSIPATION RA TING TABLE
T
= 25°C DERATING FACTOR T
= 70°C
PACKAGE
A
POWER RATING ABOVE TA = 25°CAPOWER RATING
D 725 mW 5.8 mW/°C 464 mW
P 1000 mW 8.0 mW/°C 640 mW
recommended operating conditions
MIN NOM MAX UNIT
Supply voltage, V
CC
4.75 5 5.25 V
High-level input voltage, V
IH
2 V
Low-level input voltage, V
IL
0.8 V
High-level output current, I
OH
–50 mA
Low-level output current, I
OL
50 mA
Operating free-air temperature, T
A
0 70 °C
Loading...