Testo 310 Operating Manual

testo 310 flue gas analyser

Brief instructions

These brief instructions provide an overview over the most important functions
of the product. Before using the product, you must read and follow the
instruction manual!

The instrument has two configuration menus. The menu that is
opened depends on the instrument status when called up.

Commissioning/instrument configuration menu

Area version, measurement units, time and date can be set.

When the instrument is switched on initially, the configuration menu is
opened automatically.

1. Switch the instrument on: hold down [] until all segments are shown on
the display.

2. Open instrument configuration menu: Press right function key [set] during
the initialisation phase.

3. Make settings:

[] switches to the next parameter, while [esc] takes you to the

previous parameter.

Parameter Explanation

ArEA (area

version)

Pressure,
temperature

Time, date

Selecting the area version activates different calculation
formulas and associated measurement parameters.

> Select area version code: [▲] and [▼].

1: USA, HU, IN, KR / 2: GB, RU, IT, CZ, DK, AU, JP, CN /
3: NL, SE, TR, RO / 4: DE, AT, CH, FR, ES, BE, PL, PT,

AR, BR

> Confirm the entry: [OK].

> Select the unit: [▲] and [▼], confirm the entry: [OK].

> Select the parameter: [], set the values: [▲] and [▼],

confirm the entry: [OK].

Measurements configuration menu

Fuels and measurement units can be set.

1. Switch the instrument on: hold down [] until all segments are shown on

the display.

2. Open Measurements configuration menu: After the instrument initialisation

phase, press the right function key ([set]).

3. Make settings:

[] switches to the next parameter, while [esc] takes you to the

previous parameter.

Parameter Explanation

Fuel

> Select the fuel: [▲] and [▼], switch to the next parameter:

[].

Pressure

> Select the unit: [▲] and [▼], switch to the next parameter:

[].

Temperature

> Select the unit: [▲] and [▼], confirm the entries: [OK].

Preparing measurements

After switching on the instrument or selecting a flue gas ( ) or ambient CO

probe ( ) measurement, the gas sensors are zeroed and the combustion air
temperature is measured: the flue gas probe must be close to the burner's fresh
air inlet duct!

1. Switch the instrument on: hold down [] until all segments are shown on

the display.

2. Select the fuel: [▲] and [▼], confirm the entry: [OK].

Performing the measurement

Measure-

Explanation

ment type

Flue gas

> Select : [] → [OK].

1. Start measurement: [Start].
> Edit reading display line 1/line 2: [▲] / [▼].

2. End measurement: [Stop].
> Remove flue gas probe from the flue gas duct and purge with

fresh air.