2800MWB
SINGLE LINE
INSTALLATION
AND USER GUIDE
®
COMPLIANCE AND SAFETY
As specified by FCC regulation, we are required to inform you of specific governmental and
compliance regulatory requirements, safety notices, safety instructions and other informative
information. TeleMatrix, Inc. provides this information in a separate manual. We pack the
separate Compliance and Safety Manual within each outer box or product box when shipped.
Prior to reading this operation manual and prior to setting up your telephone, please refer to
the Compliance and Safety Manual.
If the Compliance and Safety Manual is not immediately available. Please obtain a free copy by
calling our Priority Care Department (phone number 1-800-462-9446) or by downloading a copy
on our Internet (web site address www.telematrixusa.com).
Features ...........................................………..……………………………………................................... 1
Controls ...........................................................................……………………………………………….. 2
Installation .....................................................................……………………………………………........ 4
Switch Settings .....................................….......................……………………………………………...... 6
Wall Mounting .....................................….......................……………………………………………........ 7
Programming Speed Dial Memory .................................……………………………………………....... 8
Operation ........................................................................……………………………………………..... 10
Care and Maintenance ..................................................……………………………………………....... 11
Service …………………………………………………..……………………………………….………… 12
Warranty .......................................................................……………………………………………....... 13
CONTENTS
FEATURES
?? One Line
?? Convenient Data Port
?? Neon/LED Message Waiting Lamp Switch
?? Tone Dialing
?? Handset Volume Control
?? HI/LOW Ringer Volume Control Switch
?? Desk or Wall Mountable
?? Fully Modular, Easy To Install
1
CONTROLS
2
DEFINITION OF CONTROLS
1. Handset ..........…………..………….........…... Hearing aid compatible, low profile styling.
2. Ringer Controls ………………….……………. Adjusts the volume of the ringers to HI/LOW setting.
3. Handset Clip …………………………………... Retains the handset when the phone is wall mounted.
4. Handset Jack ……………………………….… Modular receptacle where handset cord plugs into the base unit.
5. Dial Pad ………………………………….…….. Large keys used for dialing.
6. Handset Volume Control ……………….…….. Increase the loudness of the receiver volume when pressed.
7. Data Port ……………………………………….. Used to connect a computer modem, fax machine, or answering device.
8. Message Waiting Selector Switch ………….. Select optional 90VDC or Low voltage LED Message Waiting.
3
INSTALLATION
Parts Check List
The following parts are included in this package:
1. 15’ modular telephone line cord.
2. Modular coiled handset cord.
3. Base unit
4. Handset
Caution
?? Never install telephone wiring during a lightning storm.
?? Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
?? Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface.
?? Use caution when installing or modifying telephone lines.
4
Parts not included wall mount wedge. Call customer service for wall mount wedge. @ 800 462 9446
Figure 3
Connecting The Handset Cord
A 10’ modular coil handset cord is provided.
To install, simply plug one end of the handset
cord into the modular jack on the handset.
The remaining end of the handset cord plugs
into the jack labeled “Handset” located on the
left side of the base unit.
(figure 3)
INSTALLATION
Connecting The Line Cord
A 15’ modular line cord is provided.
To install, simply plug one end of the line
cord into the modular jack located on the
back of the base unit. The remaining end of
the line cord plugs into the wall jack.
(figure 4)
Figure 4
5
SWITCH SETTINGS
There are installer selectable switches located on the bottom of the base unit. These switches are hidden behind a plastic cover for
security. To locate, remove the plastic covers using a sharp pointer or paper clip as shown.
Message Waiting Selector
The 2800MWB can support 90VDC neon or low-voltage LED message waiting
systems. Simply slide the switch to the desired position that is compatible with your
PBX messaging system.
Note: the phone is factory preset to the “Neon” setting.
6
Figure 5
WALL MOUNTING
Wall Mounting Your 2800MWB
The 2800MWB was designed to be conveniently wall mounted.
There is no additional hardware required. Follow these easy
steps:
1. The handset retaining clip must be engaged to secure the
handset when hanging up. To engage the clip, unsnap the
clip, rotate the clip 180º and then snap the clip into place.
(figure 7)
2. Plug one end of a short line cord (not included) into the line
jack on the back of the Marquis base unit. Plug the remaining
end of the short line cord into the wall jack. Next, guide the
phone onto the studs of the wall jack. Pull down firmly until you
feel it snap into place. The unit is now wall mounted. (figure 8)
Figure 7
7
1. UNSNAP
2. ROTATE 180 .
3. SNAP INTO PLACE.
Figure 8
WEDGE
2.SNAP INTO PLACE.
TABS.
1.PRESS THE RELEASE
MOUNTING
OPERATION
A. PLACING A CALL USING THE HANDSET
?? Lift the handset.
?? Dial out by using the numeric dial pad or by
pressing a speed dial location.
B. RECEIVING A CALL USING THE HANDSET
?? lift the handset when ringing.
8
HANDSET VOLUME CONTROL
The handset volume control increases
the volume of the handset.
When the handset is off hook, press
the volume control key to increase the
headset volume. The volume control is
a HI/LOW operation. It is hearing aid
compatible.
CARE AND MAINTENANCE
Wipe the telephone with a damp cloth occasionally to keep it looking new.
Do not use harsh chemicals, cleaning solvents, or strong detergents to clean
the system.
Keep the telephone dry. If it gets wet, wipe it dry immediately. Liquids
might contain minerals that can corrode the electronic circuits.
Use and store the telephone only in normal temperature environments.
Temperature extremes can shorten the life of electronic devices, damage
batteries, and distort or melt plastic parts.
Keep the telephone away from excessive dust and dirt that can cause
premature wear of parts.
9
SERVICE
When problems arise during installation or service that cannot be resolved using this or related
documents, contact the TeleMatrix Technical Service department 8:30a.m. - 4:30p.m. MST:
Toll Free: 1-800-462-9446
Direct: 719-638-8821
Fax: 719-638-8815
www.telematrixusa.com
Many times a problem is either installation or user related. Please contact TeleMatrix PRIOR to
sending a telephone to our service center for repair. In the unlikely event that a factory repair be
necessary:
1. Include a brief description of the trouble that you are experiencing.
2. Include a proof of purchase for a repair under warranty.
3. Send the telephone prepaid by UPS or Parcel Post insured to:
TeleMatrix, Inc.
Customer Care Center
5025 Galley Road
Colorado Springs, CO. 80915
TeleMatrix will pay to return the repaired telephone to you. Allow 2-3 weeks for delivery.
10
WARRANTY
STATEMENT OF LIMITED WARRANTY
TeleMatrix, Inc. and TeleMatrix Equipment, LLC (TMX) warrants to its [original end customer] [purchaser] that Spectrum, Spectrum Plus and Marquis
branded products manufactured by TMX are free from defects in materials and workmanship for five (5) years after the date of purchase, and Regency
branded products manufactured by TMX are free from defects in materials and workmanship for three (3) years, other than the following products for
which the warranty period shall be one (1) year: handset batteries, either NiCd or NiMH, used in TMX cordless products. If a product fails this warranty
during the warranty period, TMX will, at its option, either repair or replace the defective product or parts, or deliver replacements for defective products
or parts on an exchange basis at no additional charge to the customer except as set forth below. Repair parts or replacement products may be either
new or reconditioned. Products or parts returned to TMX under this warranty will become the property of TMX. Warranties on products repaired by
TMX expire at the termination of the original warranty period.
This limited warranty does not cover:
1. Products or parts which are damaged, abused or misused;
2. Any damage resulting from improper installation, maintenance or operation of the product;
3. Damage resulting from unauthorized modification or repair of the product, or from improper connection of the product to other equipment;
4. Cords, connectors and replaceable batteries;
5. Damage in transit to the TMX repair facility;
6. Any product or part unless proof of date of purchase is submitted with the product when returned for warranty repair; or
7. Costs incurred by the customer in removing and shipping the product to TMX for repair or replacement, and costs of reinstallation of the
product.
8. Products or parts which are not owned and used by the original end user customer.
The cost and risk of loss or damage for sending the product to TMX will be borne by the customer.
TMX EXPRESSLY DISCLAIMS ALL WARRANTIES EXCEPT THE LIMITED WARRANTY SET FORTH HEREIN, WHICH IS THE SOLE AND EXCLUSIVE WARRANTY OF THE
PRODUCT, AND IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER ORAL OR WRITTEN, EXPRESS OR IMPLIED, OR STATUTORY. THERE ARE NO IMPLIED WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THE CUSTOMER’S SOLE REMEDY UNDER THE TMX WARRANTY SHALL BE REPAIR OR REPLACEMENT
AS PROVIDED ABOVE. IN NO EVENT WILL TMX BE LIABLE TO CUSTOMER OR ANY OTHER PARTY FOR ANY INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING, WITHOUT LIMITATION, DAMAGES OF LOST PROFITS, LOST REVENUES, LOSS OF USE OF FACILITIES OR EQUIPMENT, OR COST OF SUBSTITUTE
EQUIPMENT ARISING OUT OF THE USE OR INABILITY TO USE THIS PRODUCT, EVEN IF THE CUSTOMER HAS ADVISED TMX OF THE POSSIBILITY OF SUCH DAMAGES.
TMX LIABILITY FOR DAMAGES SHALL NOT EXCEED THE PURCHASE PRICE OF THE DEFECTIVE PRODUCT.
This limited warranty is non-transferable without the prior written approval of TMX. It gives the customer specific legal rights. The customer may
have other rights which vary under local law. Some jurisdictions may not allow limitations on the term of an implied warranty or exclusions or
limitations of incidental or consequential damages.
14
This page was intentionally left blank.
252-0272-1 (2800MWB)
Revision May 1, 2003
Loading...