Tektronix TL725 User manual

TL725 English Instruction Sheet

Page 1

TL725

2x4-Wire Ohms Tweezers Test Leads

Instruction Sheet

Introduction

The Tektronix TL725 TWZ 2X4-Wire Tweezers Test Leads are
designed for use with the Tektronix DMM4020, 4040, and 4050
multimeters. The split contacts of the test lead’s banana plugs
are aligned to mate with the split contacts of the DMM4020,
4040, and 4050 HI and LO input connectors.

The split contact design of the meters and the test leads bring
both the input and sense terminals of the meters to any 4-wire
resistance measurement with only two, instead of four test leads.

PN 3481455

*P071269500*

071269500

TL725 English Instruction Sheet
Page 2

Safety Information

 Warning

To avoid possible electric shock or personal injury:

• Do not use the test leads to measure voltages
above 30 V rms, 42.4 V peak or 60 V dc.
Voltages above these levels will cause electric
shock.

• Do not use the test leads for measurements
within Measurement Categories II, III, and IV.

• Use the test leads only as specified or the
protection provided may be impaired.

• Do not use the test leads if they are cracked or
have exposed metal.

• Do not exceed the test lead’s voltage and
current rating.

• Make sure test leads are fully mated to the
instrument and accessories.

• Keep fingers behind the finger guards

• Adhere to local and national safety codes.

• Individual protective equipment must be used

to prevent shock and injury.







International Symbols

gninaeM lobmyS

Earth ground

Hazardous voltage

Risk of danger. Important information. See
instruction sheet.

Double Insulated