TL725 English Instruction Sheet
Page 1
TL725
2x4-Wire Ohms Tweezers Test Leads
Instruction Sheet
Introduction
The Tektronix TL725 TWZ 2X4-Wire Tweezers Test Leads are
designed for use with the Tektronix DMM4020, 4040, and 4050
multimeters. The split contacts of the test lead’s banana plugs
are aligned to mate with the split contacts of the DMM4020,
4040, and 4050 HI and LO input connectors.
The split contact design of the meters and the test leads bring
both the input and sense terminals of the meters to any 4-wire
resistance measurement with only two, instead of four test leads.
PN 3481455
*P071269500*
071269500
TL725 English Instruction Sheet
Page 2
Safety Information
Warning
To avoid possible electric shock or personal injury:
• Do not use the test leads to measure voltages
above 30 V rms, 42.4 V peak or 60 V dc.
Voltages above these levels will cause electric
shock.
• Do not use the test leads for measurements
within Measurement Categories II, III, and IV.
• Use the test leads only as specified or the
protection provided may be impaired.
• Do not use the test leads if they are cracked or
have exposed metal.
• Do not exceed the test lead’s voltage and
current rating.
• Make sure test leads are fully mated to the
instrument and accessories.
• Keep fingers behind the finger guards
• Adhere to local and national safety codes.
• Individual protective equipment must be used
to prevent shock and injury.
International Symbols
gninaeM lobmyS
Earth ground
Hazardous voltage
Risk of danger. Important information. See
instruction sheet.
Double Insulated
TL725 English Instruction Sheet
Page 3
International Symbols continued
gninaeM lobmyS
Equipment Recycling. This product complies with
the European Union’s requirements according to
Directive 2002/96/EC on waste electrical and
electronic equipment (WEEE). For more information
about recycling options, check the Support/Service
section of the Tektronix Web site
(www.tektronix.com).
Cleaning
Cleaning the leads with a soft cloth, mild soap, and water. To
avoid damage, do not use abrasives or solvents to clean the
leads.
Specifications
Maximum Voltage between test lead and ground: 30 V rms,
42.4 V peak or 60 V dc
Maximum Current: 1 A.
Temperature
Operating: 0 to 55 ºC < 90% relative humidity
Storage: -40 to +70 ºC
Altitude: 2000 m
TL725 English Instruction Sheet
Page 4
Contacting Tektronix, Inc.
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical support:
- In North America, call 1-800-833-9200.
- Worldwide,
visit www.tektronix.com
Copyright © Tektronix. All rights reserved. Licensed software
products are owned by Tektronix or its subsidiaries or suppliers,
and are protected by national copyright laws and international
treaty provisions.
to find contacts in your area.
Tektronix products are covered by U.S. and foreign patents,
issued and pending. Information in this publication supersedes
that in all previously published material. Specifications and price
change privileges reserved.
TEKTRONIX and TEK are registered trademarks of Tektronix,
Inc.
Warranty Information
For warranty information, go to www.tektronix.com/service, and
then use the provided links to search for your product’s
warranty.
Loading...