TL710 English Instruction Sheet
Page 1
TL710
Premium Test Leads
Instruction Sheet
Introduction
Premium test lead set features:
• Unique comfort grip probes
• Silicone insulated test leads withstand high
temperatures and remain flexible in cold
temperatures
• Lead length: 1.5 meters
• Compatible with all instruments that accept
standard 4 mm shrouded banana connectors
• Recommended for mV measurements
• Conforms to safety standard EN/IEC 61010-
031:2002 + A1:2008 and ANSI/CSA/UL 61010031:2007, 1000 V CAT II, Pollution Degree 2
• Maximum current: 10 Amps,
Maximum altitude: 2,000 meters,
Temperature rating: 0 to 55 °C
• One year warranty
PN 071-2703-01 Rev. 1, 6/2011
TL710 English Instruction Sheet
Safety Information
XW Warning
To avoid possible electrical shock or personal
injury:
.
• Do not use in CAT III or CAT IV environments
• Do not exceed the Measurement Category (CAT)
rating of the lowest rated individual component of a
product, probe, or accessory
• Use the test leads only as specified, or the
protection provided may be impaired
• DO NOT USE above maximum ratings
• Inspect test lead components for damage and
check for continuity. DO NOT USE test leads that
are damaged, or that have the inner contrasting
color of the wire exposed, or that show high
resistance
• Clean with a soft towel moistened with water and
mild detergent. DO NOT IMMERSE in liquid
• Intended for use only with instruments that have
adequate arc explosion protection
• Make sure test probes are firmly connected to
instrument and other accessories
• Do not use in wet or damp locations
Page 2
TL710 English Instruction Sheet
Page 3
Explanation of Symbols
Symbol Meaning
T
W
CAT II
CAT III
CAT IV
~
Parts protected throughout by DOUBLE
INSULATION or REINFORCED INSULATION
Caution, refer to this documentation
Product is designed to protect against transients in
equipment such as household appliances, portable
tools, and wall outlets.
Product is designed to protect against transients in
fixed-equipment installations at the distribution level.
Product is designed to protect against transients
from the primary supply level, such as an electricity
meter or an overhead or underground utility service.
Equipment Recycling. This product complies with
the European Union’s requirements according to
Directive 2002/96/EC on waste electrical and
electronic equipment (WEEE). For more information
about recycling options, check the Support/Service
section of the Tektronix Web site (www.tektronix.com).
TL710 English Instruction Sheet
Page 4
Contacting Tektronix, Inc.
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical support:
- In North America, call 1-800-833-9200.
- Worldwide,
visit
www.tektronix.com to find contacts in your area.
Copyright © Tektronix. All rights reserved. Licensed software
products are owned by Tektronix or its subsidiaries or suppliers,
and are protected by national copyright laws and international
treaty provisions.
Tektronix products are covered by U.S. and foreign patents,
issued and pending. Information in this publication supersedes
that in all previously published material. Specifications and price
change privileges reserved.
TEKTRONIX and TEK are registered trademarks of Tektronix,
Inc.
Warranty Information
For warranty information, go to www.tektronix.com/service, and
then use the provided links to search for your product’s
warranty.
Loading...