TL705 English Instruction Sheet
Page 1
TL705
2x4-Wire Ohms Test Leads
Instruction Sheet
Introduction
The Tektronix TL705 2X4 Wire Ohms Test Leads are designed
for use with the Tektronix DMM4040 and 4050 multimeters. The
split contacts of the test lead’s banana plugs are aligned to mate
with the split contacts of the DMM4040 and 4050 HI and LO input
connectors.
The split contact design used by both the meters and the test
leads bring both the input and sense terminals of the meters to
any 4-wire resistance measurement with only two, instead of four
test leads.
PN 3481298
*P071269600*
071269600
TL705 English Instruction Sheet
Page 2
Safety Information
Warning
To avoid possible electric shock or personal injury:
• Do not use the test leads to measure line
voltages. CAT I is for measurements performed
on circuits not directly connected to a mains
supply.
• Do not use the test leads for measurements
within Measurement Categories II, III, and IV.
• Use the test leads only as specified, or the
protection provided may be impaired.
• Do not use the test leads if they are cracked or
have exposed metal.
• Do not exceed the test lead’s voltage and
current rating.
• Before use, make sure test leads are fully mated
to the instrument and accessories.
• Keep fingers behind the finger guards.
• Adhere to local and national safety codes.
• Individual protective equipment must be used
to prevent shock and injury.
International Symbols
gninaeM lobmyS
Hazardous voltage
Risk of danger. Important information. See
instruction sheet.
Double insulated
TL705 English Instruction Sheet
Page 3
International Symbols continued
gninaeM lobmyS
Equipment Recycling. This product complies with
the European Union’s requirements according to
Directive 2002/96/EC on waste electrical and
electronic equipment (WEEE). For more information
about recycling options, check the Support/Service
section of the Tektronix Web site
(www.tektronix.com).
Cleaning
Clean the leads with a soft cloth, mild soap, and water. To avoid
damage, do not use abrasives or solvents to clean the leads.
Specifications
Maximum Voltage between test lead and ground:
1000 V ( CAT I )
Maximum Transient Overvoltage and Input Voltage
combined: 1000 V
Maximum Current: 500 mA
Temperature
Operating: 0 to 55 ºC <90 % relative humidity
Storage: -40 to +70 ºC
Altitude: 2000 m
Safety: Complies with EN/IEC 61010-031:2002 and
ANSI/CSA/UL 61010-031:2007 for Measurement Category I
1000 V, Pollution Degree 2.
TL705 English Instruction Sheet
Page 4
Contacting Tektronix, Inc.
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical support:
- In North America, call 1-800-833-9200.
- Worldwide,
visit www.tektronix.com
Copyright © Tektronix. All rights reserved. Licensed software
products are owned by Tektronix or its subsidiaries or suppliers,
and are protected by national copyright laws and international
treaty provisions.
to find contacts in your area.
Tektronix products are covered by U.S. and foreign patents,
issued and pending. Information in this publication supersedes
that in all previously published material. Specifications and price
change privileges reserved.
TEKTRONIX and TEK are registered trademarks of Tektronix,
Inc.
Warranty Information
For warranty information, go to www.tektronix.com/service, and
then use the provided links to search for your product’s
warranty.
Loading...