xx
THSBAT
Rechargeable Battery Pack
Instructions
Description
The THSBAT battery pack is for use with THS3000 series
oscilloscopes. The 10.8 VDC battery pack consists
of an array of Lithium-Ion battery cells. An internal
circuit monitors the charge on the battery and reports the
condition on an LCD display at the top of the battery. The
display indicates the amount of charge in increments of
approximately 20% each.
Safety Summary
To avoid potential hazards, use this product only as
specified.
Retain product literature.
information for future reference.
To Avoid Fire or Personal Injury
Use proper battery charger.
or the THS3000 series oscilloscope to charge the THSBAT
Lithium-Ion battery pack.
Do not operate with suspected failures.
is damage to the battery, charger, or power supply, have it
inspectedbyqualified service personnel.
Do not operate in wet/damp conditions.
Keep product surfaces clean and dry.
Retain the original product
Use only the THSCHG charger
If you suspect there
Safety Terms in This Manual
CAUTION.
practices that could result in damage to the equipment
or other property.
Safety Symbols and Terms on the Product
DANGER indicates an injury hazard immediately accessible
as you read the marking.
WARNING indicates an injury hazard not immediately
accessible as you read the marking.
CAUTION indicates a hazard to property including the
product.
Battery Recycling
This THSBAT Lithium-Ion rechargeable battery pack must
be recycled or disposed of properly.
Lithium-Ion batteries are subject to disposal and
recycling regulations that vary by country and region.
Always check and follow your applicable regulations
before disposing of any battery. Contact Rechargeable
Battery Recycling Corporation (www.rbrc.org) for
U.S.A. and Canada, or your local battery recycling
organization.
Many countries prohibit the disposal of waste electronic
equipment in standard waste receptacles.
Place only discharged batteries in a battery collection
container. Use electrical tape or other approved
covering over the battery connection points to prevent
short circuits.
These statements identify conditions or
This symbol indicates that this product
complies with the applicable European Union
requirements according to Directives 2002/96/EC
and 2006/66/EC on waste electrical and
electronic equipment (WEEE) and batteries. For
information about recycling options, check the
Support/Service section of the Tektronix Web site
(www.tektronix.com).
Transporting Lithium-Ion Batteries
The capacity of the Lithium-Ion rechargeable battery pack
in this product is under 100 Wh. The lithium equivalent
content has been shown to meet the applicable requirements
as defined by the UN Manual of Tests and Criteria Part III
Subsection 38.3.
Always check all applicable local, national, and
international regulations before transporting a
Lithium-Ion battery.
Transporting an end-of-life, damaged, or recalled
battery may, in certain cases, be specifically limited or
prohibited.
The battery pack must be adequately protected against
short-circuit or damage during transport.
Storing Battery Packs
Store battery packs in a low-humidity environment
free of corrosive gases. Storing battery packs
in high-humidity environments, or outside the
temperature range, can cause oxidation on the
metallic parts, increased leakage, significant aging and
premature failure.
Do not store battery packs near heat or fire. Do not
store in the sunlight.
Do not keep battery packs in a place where the
terminals can be shorted by metal objects (for example,
coins, paper clips, or pens).
Do not remove a battery pack from its original
packaging until required for use.
When possible remove the battery pack from the
equipment when not in use.
Charge the battery to approximately 50% of capacity at
least once every six months.
Remove the battery and store it separately from
the oscilloscope. Refer to the THS3000 Series
Oscilloscope User Manual for instructions on
removing and installing the battery.
For optimal battery life, store the battery at
temperaturesbetween+5°Cand+20°C(+41°F
and +68 °F). Higher temperatures reduce the battery
storage life.
*P071296000*
x
071-2960-00
Charging the Battery Pack
The battery pack charges automatically when the
oscilloscope is connected to the external power supply. You
can also charge the battery pack with the external power
supply and the optional THSCHG battery charger base.
You do not need to continuously charge (trickle charge)
Li-Ion battery packs to maintain full operating capacity
between jobs. However, a Lithium-Ion battery pack will
self-discharge during non-use. To achieve the longest
operating time, charge your battery pack before use. If you
plan to store battery packs, read the specific instructions to
do this. Do not leave a battery on prolonged charge when
not in use.
When the battery pack is in the oscilloscope, the gauge
icon on the oscilloscope display indicates the amount of
charge in increments of approximately 25% each. You can
also access battery information through the Version and
Calibration tab in the oscilloscope User menu.
To avoid automatic shutdown of the battery pack, only
run the oscilloscope on the battery pack when the gauge
on the oscilloscope indicates 25% or more charge.
To ensure the accuracy of the gauge, occasionally
allow the oscilloscope to run on the battery pack until
automatic shutdown occurs.
Always verify the correct placement of the battery in
the product or the External Battery Charger.
CAUTION.
only the oscilloscope or the THSCHG battery charger
to charge the battery pack. Do not connect any other
voltage source to the battery pack.
CAUTION.
during charging, do not exceed the allowable ambient
temperature given in the specifications.
NOTE.
pack completely before using it for the first time or after
prolonged storage.
To discharge the battery pack completely, continue to
run the oscilloscope on the battery pack until automatic
shutdown occurs.
To avoid damage to the battery pack, use
To avoid overheating of the batteries
For optimum performance, charge the battery
To prolong the life of the battery pack and to prevent
NOTE.
shutdown, do not operate or charge the battery pack at
high temperatures. For best results, allow the battery pack
to cool to room temperature before using or charging the
battery pack.
Cold temperatures adversely affect the normal
electrochemical reactions within a battery pack, reducing
the available capacity. You can minimize this loss by
keeping the battery packs at room temperature prior to and
during use.
Do not leave a battery pack discharged for extended periods.
See the Storing Battery Packs section for information on
how to properly store a battery pack.
The battery pack switches to trickle charging when the
battery pack is fully charged.
Battery Use Guidelines
Do not leave a battery unused for an extended period of
time, either in the product or in storage. When a battery
has been unused for six months, check the charge status,
and charge or dispose of the battery as appropriate. See
Charging the Battery Pack and Battery Recycling.
The typical estimated life of a Lithium-Ion battery is about
two to three years, or 300 to 500 charge cycles, whichever
occurs first. One charge cycle is a period of use from fully
charged, to fully discharged, and fully recharged again. You
should use a two to three year life expectancy for batteries
that do not run through complete charge cycles.
A rechargeable Lithium-Ion battery has a limited life and
will gradually lose its capacity to hold a charge. This loss
of capacity (aging) is irreversible. As the battery loses
capacity, the length of time it will power the product (run
time) decreases.
A Lithium-Ion battery continues to slowly discharge
(self-discharge) when not in use or while in storage. You
need to routinely check the charge status of the battery.
Use the battery only in the application for which it is
intended. Use only THSBAT battery packs in your
THS3000 series oscilloscope.
Maintaining the Battery Pack
Observe and note the run time that a new fully-charged
battery provides for powering your product. You can
use this new battery run time as a basis to compare run
times for older batteries. The run time of your battery
will vary depending on the product’s configuration and
the applications that you run.
The battery pack gives the best performance when
operated at normal room temperature, 20 °C ±5 °C
(68°F±9°F).
Routinely check the charge status of the battery.
Carefully monitor a battery that is approaching the end
of its estimated life.
Consider replacing the battery with a new one if
the battery run time drops below about 80% of the
original run time, or the battery charge time increases
significantly.
Follow the storage requirements if you store or do not
use a battery for an extended period. If you do not
follow the storage requirements, and the battery will
not power the oscilloscope when installed, consider the
battery to be damaged. Do not connect power to the
oscilloscope during this time. Remove the battery pack
from the oscilloscope. Do not attempt to recharge or
reuse the battery. Replace it with a new battery.
Handling Battery Packs
Do not disassemble, crush, or puncture the battery.
Do not short the external contacts on the battery.
Do not dispose of the battery in fire or water.
Do not expose the battery to temperatures above
+60 °C (+140 °F).
Seek medical advice if a battery or part of it has been
swallowed.
Do not put battery packs near heat or fire. Do not put
in sunlight.
Keep the battery pack clean and dry. Clean dirty
connectors with a dry, clean cloth.
Batteries contain hazardous chemicals that can cause
burns or explode. If exposure to chemicals occurs,
clean with water and get medical aid. Repair the
product before use if the battery leaks.
Do not attempt to open, modify, reform or repair a
battery pack that appears to be malfunctioning, or
which has been physically damaged.
Keep the battery away from children and animals.
Avoid exposing the battery to excessive shock or
vibration.
Do not use a damaged battery or charger.
If a battery pack has leaking fluids, do not touch any
fluids. Dispose of a leaking battery pack. See the
Battery Recycling section for information on Disposal
and Recycling.
In case of eye contact with fluid, do not rub eyes.
Immediately flush eyes thoroughly with water for at
least 15 minutes, lifting upper and lower lids, until no
evidence of the fluid remains. Seek medical attention.
Specifications
Characteristic Description
Capacity
Output 10.8 VDC
Operating
temperature
Storage temperature -20 °C to +60 °C (-4 °F to +140 °F)
Weight (including
packaging)
52 Wh, 4.8 Ah
0 °C to +45 °C (+32 °F to +113 °F)
351 gm (12.4 oz)
Warranty Information
For warranty information, go to the www.tektronix.com
Web site, and search for “THSBAT warranty”.
Contacting Tektronix
Tektronix, Inc.
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical
support:
In North America, call 1– 800–833–9200.
Worldwide, visit www.tektronix.com to find contacts
in your area.
Copyright © Tektronix, Inc. All rights reserved. www.tektronix.com
Loading...